About Us

Subject: Fuel transfer/polishing pump
From: "Doug Dotson"

They have to, and there is usually a hole through the baffles at the
lowest point of each baffle.

Have to what?

Capt. Bill

Have to have tunnels between the baffles.

"LaBomba182" wrote in message
...
Subject: Fuel transfer/polishing pump
From: "Doug Dotson"

They have to, and there is usually a hole through the baffles at the
lowest point of each baffle.

Have to what?

Capt. Bill

Subject: Fuel transfer/polishing pump
From: "Doug Dotson"

Have to have tunnels between the baffles.

Yes.

Capt. Bill

Subject: Fuel transfer/polishing pump
From: "Doug Dotson"

Have to have tunnels between the baffles.

Yes.

Capt. Bill

Have to have tunnels between the baffles.

"LaBomba182" wrote in message
...
Subject: Fuel transfer/polishing pump
From: "Doug Dotson"

They have to, and there is usually a hole through the baffles at the
lowest point of each baffle.

Have to what?

Capt. Bill

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem changing out my fuel pump	Derek	General	2	July 3rd 04 01:50 PM
Engine dies- Putters when trying to plane- engine under under heavy load	Bora Cider	General	4	May 18th 04 04:12 PM
Can a single 72 gal per hour fuel pump run two 392 cu inch motors?	Scott Downey	General	4	October 19th 03 09:28 PM
Inboard won't run above 2800 RPM	John M Murphy	General	2	August 18th 03 05:27 PM
Fuel pump to carbs fuel line replacement	Bob	General	5	July 29th 03 05:51 PM

Menu

About Us