Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]()
I am adding a trysail track to my Catalina 38. The mast has an
internal track for the main, and I'm adding an external track for the trysail. I have noticed that most of the tracks I've looked at extend down almost to the cabin top. Is there a reason to do so? Also, I've been told that the track should be on the starboard side, but not why it should be there. Finally, I'm trying to decide where the track should go. I'm thinking that it should be as far aft as possible, but offset enough to be clear of the internal groove. I will appreciate any comments or suggestions. Jim Williams Checks in the Mail Norfolk, VA |
#2
![]() |
|||
|
|||
![]()
On Sun, 23 May 2004 13:40:38 GMT, JAWs wrote:
I am adding a trysail track to my Catalina 38. The mast has an internal track for the main, and I'm adding an external track for the trysail. I have noticed that most of the tracks I've looked at extend down almost to the cabin top. Is there a reason to do so? Also, I've been told that the track should be on the starboard side, but not why it should be there. Finally, I'm trying to decide where the track should go. I'm thinking that it should be as far aft as possible, but offset enough to be clear of the internal groove. =========================================== By extending the track almost to the cabin top, you can store the storm trysail attached to the track and in the bag. That's a big convenience if you're trying to get it up in typical trysail conditions. I believe the starboard side recommendation stems from the tradition of having the main halyard on the starboard side. That would leave you on the starboard side of the boom for everything involved with the hoist. |
#3
![]() |
|||
|
|||
![]()
Check the width of your trysail slides before installing the track.. See if
the can be hoisted "behind" the main while it is reefed down or on the boom, without. Ideally the trysail should be able to clear the sail folds and ride above the head board of the main. Often hard to achieve but is the ideal arrangement. This may mean that the lower 'feeder' track will come around to the side of the mast several inches, but that won't effect the trysail once you have hoisted it above the main. This has created a problem with my new fill batten main. The main sail stack is about 4 ft above the boom due to the height of the four batten cars and the intermediate slide cars. (I really have to stretch to reach the head board/halyard). I haven't had my storm trysail made up yet but I may have some problems since my mainsail stack is so high. Good Luck. Steve s/v Good Intentions |
#4
![]() |
|||
|
|||
![]()
On Sun, 23 May 2004 16:44:18 -0700, "Steve" wrote:
Check the width of your trysail slides before installing the track.. See if the can be hoisted "behind" the main while it is reefed down or on the boom, without. Ideally the trysail should be able to clear the sail folds and ride above the head board of the main. Often hard to achieve but is the ideal arrangement. This may mean that the lower 'feeder' track will come around to the side of the mast several inches, but that won't effect the trysail once you have hoisted it above the main. This has created a problem with my new fill batten main. The main sail stack is about 4 ft above the boom due to the height of the four batten cars and the intermediate slide cars. (I really have to stretch to reach the head board/halyard). I haven't had my storm trysail made up yet but I may have some problems since my mainsail stack is so high. Good Luck. Steve s/v Good Intentions In conditions which require a trysail wouldn't it be better to remove your mainsail stack and get it below. Then the trysail could be set low with the clew attached to the cockpit sole. Boom end lowered and tied off would then be possible. I could be wrong about this but that's how I'd do it. Mark E. Williams |
#5
![]() |
|||
|
|||
![]() In conditions which require a trysail wouldn't it be better to remove your mainsail stack and get it below. Then the trysail could be set low with the clew attached to the cockpit sole. Boom end lowered and tied off would then be possible. I could be wrong about this but that's how I'd do it. Mark E. Williams Mark, what is a "mainsail stack"? jofra |
#6
![]() |
|||
|
|||
![]()
You might be able to do that on a small cruiser but I wouldn't want to
attempt to remove 450 sqft main with semi perm.(~15 ft) battens.(where would I store it??) I also have a Dutchman sail flaking system. Just not practical. It's a hastle to remove the main in port. The storm trysail can still be sheeted to cleat on deck once the boom is secured in the gallows or !!. Can't really lower the boom end with lazy jacks or Dutchman system. There is nothing wrong with setting the storm trysail above the main stack. If you look at any sail plan that included a this sail, you will see that it is designed to be high above the boom, just for this reason. My experience and opinion, FWIW. Steve s/v Good Intentions |
#7
![]() |
|||
|
|||
![]()
The "Main Sail Stack" I'm referring to is the bulk of sail that remains
above the boom, at the mast, when it is lowered and remains in the mast grove or on the sail track. Before full battens and batten cars, etc. this didn't amount to much more that a lump above the gooseneck. Now, with batten cars measureing 4-6" in height and intermediates being on similar but smaller cars, this stack has increased to several feet or as with mine, over 4 ft. It is not an easy matter to fully remove these cars and I only remove mine once a season to clean and run a lubricant wiper up and down the track.. I will admit, I'm beginning to miss the KISS of my last boat, albeit a less efficient sail. The price I pay for that extra roach and sail area, etc. Steve s/v Good Intentions |
#8
![]() |
|||
|
|||
![]()
You don't need a trysail. Where you going in a Catalina that needs a
trysail. Catalina's should not be taken out in more than 30 knots of wind. |
#9
![]() |
|||
|
|||
![]() "Jofra" wrote in message ... In conditions which require a trysail wouldn't it be better to remove your mainsail stack and get it below. Then the trysail could be set low with the clew attached to the cockpit sole. Boom end lowered and tied off would then be possible. I could be wrong about this but that's how I'd do it. Mark E. Williams If the conditions are bad enough to use a trysail, then it would be impossible to get the mainsail off and down below. jofra |
#10
![]() |
|||
|
|||
![]()
JAWs wrote:
I am adding a trysail track to my Catalina 38. The mast has an internal track for the main, and I'm adding an external track for the trysail. I have noticed that most of the tracks I've looked at extend down almost to the cabin top. Is there a reason to do so? Also, I've been told that the track should be on the starboard side, but not why it should be there. In tropical storms, like cyclones and hurricanes, winds rotate counter-clockwise in the northern hemisphere. Thus, if you find yourself on the path of tropical storm, sailing on starboard tack would get you away from the eye of the storm. Thus having the external trysail track on PORT side would help setting the trysail. If you sail into a tropical storm in the southern hemisphere, you would avoid the eye of the storm by sailing on port tack, and thus the track should be on starboard side. Finding yourself on the path of a tropical storm in a Catalina might not be a good idea.. Finally, I'm trying to decide where the track should go. I'm thinking that it should be as far aft as possible, but offset enough to be clear of the internal groove. I will appreciate any comments or suggestions. Jim Williams Checks in the Mail Norfolk, VA |
Reply |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Transducer Installation | General | |||
Ideas on how to electronically track a float at sea? | General | |||
Macerator installation | Cruising | |||
battery installation | Boat Building | |||
Bolt rope track for dodger? | Boat Building |