| Home |
| Search |
| Today's Posts |
|
#3
posted to rec.boats
|
|||
|
|||
Replacing prop....
JimH wrote:
"aieo" wrote in message ... Any "do-it-yourself" tips? I would like to avoid bribing the boat into the shop for this. '03 Johnson 115/4S and yes I have a good selection of tools. Should I get a new cotter pin or is the old one good? What type of grease, if any should be applied to the spline? Any torque recs on the castlenned nut or just screw in as far as it will go in with the pin hole alligned? Thanks, Vince I would replace the cotter pin.........SS one will set you back a whole $0.75 Use waterproof grease. Except for KY Jelly what grease is not waterproof? |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Replacing Saddam with...more of the same. | General | |||
| Replacing a mercruiser 260 HP | Cruising | |||
| replacing gel coat | Touring | |||
| Replacing tubes on RIB | Cruising | |||
| Replacing an atomic 4 | ASA | |||
Threaded Mode
