You have not answered the question on the test I gave you. Remember the
hint of long, long stroke and 2" bore.

"JAXAshby" wrote in message
...
billie, I repeat, hp IS thrust ****multiplied*** by rpm times a factor.
Remember that, that is not going to change withing your lifetime.

over square does NOT "spin faster", but rather -can- spin at greater rpm
without running into the limits of piston speed.

btw, diesels typcially are under-square.

now, yo-yo billie, a question for you. Why do diesels typically have
longer
connecting rods compared to their strokes as compared to gas engines.

Question #2: how does connecting rod length vs stroke affect degrees
rotation
of the piston at dead stop?

have fun.

From: "Calif Bill"
Date: 12/16/2004 2:26 AM Eastern Standard Time
Message-id: t

No Jaxass you did not answer the thrust / RPM question completely. And
you
explain to me how over-sq and under-sq differ. And why an over-sq engine
spins faster. Hint on your test. Use an engine with a 2" bore and a 20'
stroke.

"JAXAshby" wrote in message
...
billie, I DID answer it and answer it completely. go back and read the
posts.
get some high school kid to help you. the answer is there and it was
the
complete answer.

in addition, you did answer your question re square vs over-square
engines, in
that yes I do know the difference. now, let me ask you a question. do
*you*,
shakeytown billie, how sq vs ov-sq affects degrees rotation the piston
is
stopped at BDC? A yes or no answer is fine, while a one or two
sentence
explanation is better.

have fun.

From: "Calif Bill"
Date: 12/14/2004 10:36 PM Eastern Standard Time
Message-id: . net


"JAXAshby" wrote in message
...
billie, and you and dog pile are a pair. but let me answer your
questions.

So, Genie-ass, can you answer the very easy question?

Do you know the difference between torque and horsepower?

This question was answered, by me, a couple posts back. apparently,
you
either
were not paying attention, or you are not capable of understanding.
if
the
later, ask a high school kid to explain it to you.
next:

Do you know the difference between an over-square and an
under-square
engine?


yes. and, like tens of thousands of others, I knew the difference
while
still
an early teenager.

next?

BB



Well, then answer them. You did not answer the question regards
thrust
and
RPM and Horse power earlier. I admit you probably do know horse
****.