On 19 May 2006 20:41:25 -0700, "Mark / Amy Read"
wrote:

I have installed my ICOM SSB as Chuck described, where the lower
Isolater is 12 to 16 inches from the bottom of the deck. The wire from
the ICOM tuner runs right up the backstay to the Isolater. I used zip
ties to hold the wire in place, and then used rigging tape to hold it
all in place. I have not used any type of PVC pipe or other cover for
the backstay for heat protection. My thinking is that it only gets hot
when you are transmitting. Someone would really have to lean way out
to touch it and it would have to be at that random moment when I am
transmitting on the SSB. The rigging tape wrapped around the backstay
for three or four feet is more than enough to keep from any accidental
burns.

The backstay should not get thermally hot while you are transmitting -
but it may be electrically "hot" - anyone touching it while you are
transmitting may get a nasty RF burn - the "reachable" portion of the
backstay (and any other part of the antenna wiring) should be
electrically insulated to prevent shock or RF burns, not because of
any temperature concerns.



--
Peter Bennett, VE7CEI
peterbb4 (at) interchange.ubc.ca
new newsgroup users info : http://vancouver-webpages.com/nnq
GPS and NMEA info: http://vancouver-webpages.com/peter
Vancouver Power Squadron: http://vancouver.powersquadron.ca