Andy,

I'm sorry if 'we' wasted your time. Especially if you already knew the
answer !!

The entire discourse could have either been avoided, or taken a different
tack, if you had mentioned this fact . . . up front.

As an engineer {and a C.P.A. - 'Certified Pain in the Ass' per my wife} my
first thought, when someone ASKS ME a question, is that they want an
accurate & correct answer. It has taken me YEARS to realize that they
actually DON'T. Therefore I have adopted the 'policy' of . . . 'If you don't
like the answer . . . DON'T ASK the question !!'

Regards & Good Luck,
Ron Magen
Backyard Boatshop

wrote in message

Thank you everyone for your input. I will probably ignore the advise . .
..
SNIP
I went into the project fully aware of the impact of my materials choices.
SNIP
Andrew Butchart

Ron Magen wrote:
Andy,

I'm sorry if 'we' wasted your time. Especially if you already knew the
answer !!

The entire discourse could have either been avoided, or taken a different
tack, if you had mentioned this fact . . . up front.

snip


Sorry about the confusion. I had thought that my question was about
whether a coated 1/4" panel could be safely curved around the hull or
whether it would be too stiff or brittle. I didn't think that my
choice of resin was part of the question although I did mention it
because it was pertinent. I did sort of get an answer in that with the
poorer adhesive qualities and higher brittleness of polyester that
there was a risk of it cracking.

Andrew Butchart