Home |
Search |
Today's Posts |
#3
|
|||
|
|||
Hi Gene,
I just got my compass, the same , 70P for my Romany 16. I went out and got 4 # 4 machine screws 3/4" for the nut, with #4 washers and a nylon nut also a #4. I also got the # 4 machine screw 1/2" to minimize the steel to the compass if the 3/4" are too long. The screws that came with the compass are #4 1/2". I had to search around town for the #4 hardware but was very lucky to find them. I'll use a marine glue for the drill holes. I think the drill holes will be 7/64. I would not go up to a #6 hardware. As crazy as it may seem; its more steel to the compass. I was thinking of going without the washers to keep steel away form the compass. On the Romany 16, I drilled holes to move the rope cleat aft and no drips with marine glue. Good luck. Steve Wilmington, NC |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Compass needle versus card for cruising | Cruising | |||
Compass Information | General | |||
RDF for newbies and NN of KN | ASA | |||
Flux Compass input to radar?? | Electronics | |||
'Swinging' compass? | Cruising |