On Fri, 22 Jun 2018 20:45:58 -0400, wrote:

On Fri, 22 Jun 2018 12:35:42 -0700 (PDT), Tim
wrote:


2:18
On Fri, 22 Jun 2018 11:08:00 -0700 (PDT), Tim
- show quoted text -
Are you sure you even need the long shaft. Most of the toons I see
around here use a short shaft and mine is mounted 4" above stock.
The only place I have trouble is it can blow out on a tight turn if I
have it trimmed up too much.

,,, oh yes. I’m pretty sure. I’ll send a pic to Eddie. How’s that?

Sure. He doesn't tell me about all of the posts tho. I will be sure to
ask him about it.

I looked at the pictures and I bet you will be fine with a short shaft
on that boat
Optimally the anticavitation plate will be riding at or slightly
below the bottom of the motor pod skid. Yours appears to be 6" below
that.
The skid does seem to be at about the water line based on the mark on
the toons. A heavier motor will even make that lower. The water tends
to well up between the toons at speed so that effective water line is
even higher but it still ends up being the bottom of the motor pod
skid.
http://gfretwell.com/ftp/Tim%20boat.jpg
http://gfretwell.com/ftp/motor%20bracket.jpg

You can see I added 4" to my motor pod transom board to get the motor
up even higher.

The more motor you have in the water, the more drag you are pushing
against. As I say the only problem is you can starve the prop on a
very hard turn if you are going fast, If you are slow enough so it
squats in the turn there is no problem. It is also only on a very hard
turn up on top. You may not go that fast anyway ;-).