About Us

iBoaterer[_2_]

In article ,
says...

"JustWait" wrote in message ...

On 12/30/2012 2:34 PM, wrote:
On Sun, 30 Dec 2012 10:21:34 -0500, iBoaterer wrote:

It's still not any stronger than the base metal, period.

There is more surface as the hole is bigger, period. The type of metal
or the thickness is irrelevant, more is more... period. I knew the
engineer wouldn't know ****, take the question to a technician
tomorrow
at work and have him explain it to you, LOL!

----------------------------------------------------

Both statements are correct however to what degree is the issue. In
the case of the Ford V-10, some of the "repaired" heads using
heli-coils spit the spark plug out again after time with the failure
being the heli-coil to head interface. The benefit of being able to
remove the spark plug with less risk of taking part of the head with
it is valid, but as someone pointed out, these engines do not required
routine spark plug changes. This is what got Ford in some hot water,
meaning trying to place the blame on spark plug replacements. The
primary reason was the type of aluminum alloy used that weakened over
time due to heat cycles.

Aluminum is a unique material in the respect that it comes in many
different alloys and hardening techniques, depending on application.
The last I knew there were about 10-12 different alloys typically used
in industry and several different heat treating and aging techniques.
I became somewhat interested in this when I considered building a
large, aluminum vacuum chamber that would be routinely subjected to
very high side wall loads of about 29,000 lbs. Talking to
metallurgists and mechanical stress engineers convinced me that it
wasn't a good idea because the typical "61T6" alloy would weaken over
time. I am not a mechanical engineer nor a metallurgist, but
considering the liability risk, I decided to stick with stainless
steel.

Scotty doesn't get that the base metal is the part doing the holding.
While there is some more thread surface with the fix, it's not very
much. BUT, the fact remains, that the fix is no stronger than the base
metal, it is impossible for it to be. Same with welds. Most times, a
weld is far stronger than the base metals. Same rule applies. If the
weld is good for 50 ksi in tension and the steel that it is welded TO is
good for only 25 ksi, guess what the failure tension is? Correct, 25
ksi, why? because the connection is only as strong as the weakest
component.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
New Generator	Frogwatch[_2_]	General	77	July 3rd 11 03:34 PM
Buying a generator	Frogwatch[_2_]	General	30	June 14th 11 05:57 PM
Generator	Frank	General	5	September 21st 04 04:18 PM
portable generator	[email protected]	Electronics	11	April 23rd 04 05:30 PM
WTB in FL Generator	Frank	Electronics	0	March 10th 04 11:01 PM

Menu

About Us