sounds like ignition timing is squew wiff,pre ignition will stop the
cylinders stone dead,..take the ht leads of and see if it turns over,if it
dose,which i think it might,its time to look at the distributor......KB.
LET US KNOW THE OUTCOME, TY
wrote in message ...
Kill switch, maybe?

On 9 Sep 2004 05:28:48 -0700, (Layne Meier)
wrote:

I have an old 1976-1977 Ford 460 7.5 Liter V8 engine that I'm having
problems with. It is installed in an old 1977 jet boat (engine
attached to a Berkeley J12E Jet drive.. I was out on the lake
having a good time cruising around, pulled into a cove and shut down
the engine to swim and when I went to
start it back up it wouldn't. The engine wouldn't turn over. It was
acting like the battery wasn't charging up via the alternator. We
towed the boat to shore and trailered it home. I tested the battery
with a voltmeter and it tested at 12volts and took it to a local auto
parts store for a test and it came out fully charged with about 850
amps. I put the batter back in the boat and tried to start it up, but
it still wouldn't even crank over. I pulled the starter motor out and
had it rebuilt and put a new solenoid in as well. I've checked all
the wiring, put on new battery cables and even a new starter switch
all with the same results. It's like I'm not getting enough juice to
the starter motor, it only cranks over between 1 - 5 degrees -
certainly not enough to get it to crank over.

Anyone experienced this before and could give me a few clues.

Thank you,
Layne Meier
Atlanta, GA

I don't think so..

It'd stop it.. but not dead.

I've had timing 180 degrees off; and it'd turn it over quick at first, then stop
it; then it'd turn again.

He's getting very little turn and then STOP.

Fuel has to be delivered in order for timing to be an issue; and the 1st second;
no fuel is present....

On Wed, 15 Sep 2004 08:20:18 GMT, "k.barrett" wrote:

sounds like ignition timing is squew wiff,pre ignition will stop the
cylinders stone dead,..take the ht leads of and see if it turns over,if it
dose,which i think it might,its time to look at the distributor......KB.
LET US KNOW THE OUTCOME, TY
wrote in message ...
Kill switch, maybe?

On 9 Sep 2004 05:28:48 -0700, (Layne Meier)
wrote:

I have an old 1976-1977 Ford 460 7.5 Liter V8 engine that I'm having
problems with. It is installed in an old 1977 jet boat (engine
attached to a Berkeley J12E Jet drive.. I was out on the lake
having a good time cruising around, pulled into a cove and shut down
the engine to swim and when I went to
start it back up it wouldn't. The engine wouldn't turn over. It was
acting like the battery wasn't charging up via the alternator. We
towed the boat to shore and trailered it home. I tested the battery
with a voltmeter and it tested at 12volts and took it to a local auto
parts store for a test and it came out fully charged with about 850
amps. I put the batter back in the boat and tried to start it up, but
it still wouldn't even crank over. I pulled the starter motor out and
had it rebuilt and put a new solenoid in as well. I've checked all
the wiring, put on new battery cables and even a new starter switch
all with the same results. It's like I'm not getting enough juice to
the starter motor, it only cranks over between 1 - 5 degrees -
certainly not enough to get it to crank over.

Anyone experienced this before and could give me a few clues.

Thank you,
Layne Meier
Atlanta, GA




---
Remove x's to send.