On Mon, 08 Nov 2004 13:46:27 GMT, Rich Hampel
wrote:
First flat sand with 1300 or 2000 grit wet and dry to get a FLAT
surface; then, .... Rottenstone and water for gloss, rottenstone and
oil for semi-gloss, pumice and and oil for satin.

=========================================

When you are hand rubbing, do you use a soft cloth, sponge, or some
other material?

============================================

For a 'perfection'
surface final coat with an airbrush. The modern acrylic/urethanes can
be power buffed (with super fine diotomaceous earth etc. as the 'grit')
to make this whole hand-rub process very fast.

If you ever have the opportunity to look at the wood trim in top of the
line type of private jets or mega yachts or even automobiles.... all
the finishes are hand rubbed to a super brilliant surface. A benefit
of a flat hand-rubbed surface is longevity. The only finish that is
more brilliant than a hand rub on varnish is a 'french-polish' using
alcohol and shellac .... but that is NOT for any wet locations.

In article , Wayne.B
wrote:

=========================================

When you are hand rubbing, do you use a soft cloth, sponge, or some
other material?

============================================
Use a soft cloth. I just use a clean bare hand.