Home |
Search |
Today's Posts |
#21
|
|||
|
|||
In article ,
Jeff Morris wrote: I'm still not sure of the value for long distance viewing, but the high power dome will have finer resolution, so that a pair of channel buoys will be resolved as two targets further away with the more powerful unit. Navigation is easier, since coastlines will more closely resemble the chart. However, this takes a lot of practice and you're better off relying on a good gps. The above is due to a narrower Horizontal Beamwidth, and not the PPP (Peak Pukse Power) of the transmitter. Radar OEM's tend to put the bigger antennas (narrower Horizontal Beamwidth) on their Larger PPP transmitters as a rule, but the two are mutually exclusive specifications. Third and fourth Generation Marine Radars, all have Log Recivers, SolidState Frontends, and that is why they preform as well as the older Second Generation Radars that had twice the PPP in the transmitters. Where it used to take 10Kw and a 6 Ft SlotLine antenna to pickup 48 mile targets in second genertion Marine Radars, the 4Kw 4Ft Slotline antennas of the Fourth Generation work just fine on the same paths. Like wise the 2Kw 3Ft Slotline Radars of the Third Generation will compare very nicely with a 2Kw flatpanel antennas of todays small boat radars, with the exception of the very wide Horozontal Beamwidths of those flat panel antennas, that can't differentiate between two targets at the same distance, but closer than 6 or 7 degrees in bearing. Bruce in alaska -- add a 2 before @ |
#22
|
|||
|
|||
"renewontime dot com" wrote in message
... Just remember that a radar sends out radio waves, and any metal in front of it will cause part of your radar signal to be bounced back to your radar. The metal mast and rigging may not obscure your radar display (an empty "shadow area"), but some of that energy will be bounced right back and can either cause interference or even damage to your radar's receiver. All the more reason not to use a 4 kw system. No it won't. When the radar is transmitting, the receiver is shut off or the path from the antenna to the receiver is blocked. When the tranmission stops, the receiver is switched on again but not immediately. So the first strong echos from very nearby objects will not reach the received. Apart from that, the receivers' sensitivity is increased from almost nothing to full gradually to compensate for the weaker echos from longer distances. Meindert |
#23
|
|||
|
|||
On Mon, 14 Feb 2005 10:11:18 -1000, renewontime dot com
wrote: Just remember that a radar sends out radio waves, and any metal in front of it will cause part of your radar signal to be bounced back to your radar. The metal mast and rigging may not obscure your radar display (an empty "shadow area"), but some of that energy will be bounced right back and can either cause interference or even damage to your radar's receiver. All the more reason not to use a 4 kw system. Unless his ketch is very long indeed, any echo energy from the mast will arrive and depart while the antenna is closed. Rodney Myrvaagnes J36 Gjo/a Does one child rape really change Strom Thurmond's lifetime record? For better or worse? |
#24
|
|||
|
|||
On Mon, 14 Feb 2005 21:22:32 GMT, Me wrote:
In article , renewontime dot com wrote: Higher power doesn't "burn" through anything, including fog, Bzzzzt, wrong answer Dude, would you like to try for what is behind Door #3?????? When was the last time, you measured Water Adsorption at 10Ghz? Obviously, not in the last 50 years, since Xband has come into Marine Radar use. Water Adsoption is a Significant cause of loss of Targets, when the humidity of the air between the transmitter Perhaps you mean 'absorption?' 'Adsorption is hardly possible for rf. and target is high. 4Kw PPP wil certainly "Burn thru" more humid air than 2Kw PPP. One must also consider, that heavy rain, like in squalls, will also tend to drop the siganl level of received targets in the Xband, due to defraction of the RF by the rain droplets. These, and other KNOWN, physical elements all play a part in Maximum Detection Distance of a target in Marine Radar Systems. Me one who deals with this stuff every day...... Rodney Myrvaagnes J36 Gjo/a Does one child rape really change Strom Thurmond's lifetime record? For better or worse? |
#25
|
|||
|
|||
Jeff Morris wrote in
: I've had minor second thoughts on this after checking the specs. In the "old days" more powerful domes were heavier and used more power - that is not the case now - the 4kW Raymarine dome only weighs a few pounds more and uses 1 or 2 Watts more juice. Pot metal and plastic is much lighter, which is what the Raymarine is made from. They'll replace it when the pot metal consumes itself from the condensation of breathing in and out through the drain tube makes it rain inside the dome, though. We're on our third...(sigh) The communications on the RL70CRC also failed, which explains why we couldn't get the Seatalk Gyro/Compass to ever calibrate properly, no matter how many times we turned it slowly. They fixed that, too, but I don't think it was ever working right in the first place. Isn't it amazing how 2,000 watts of peak RF power just appears from thin air for only 1-2 watts more DC? Magic? Divine intervention? Maybe its the printer stepper motor that turns the rubber band that drives the PC board antenna array...?? I'm still not sure of the value for long distance viewing, but the high power dome will have finer resolution, so that a pair of channel buoys will be resolved as two targets further away with the more powerful unit. Navigation is easier, since coastlines will more closely resemble the chart. However, this takes a lot of practice and you're better off relying on a good gps. Ah, but you have another problem in the fog. The higher the antenna, the further away the target will disappear as the target approaches the boat! You won't see the bouy 8 miles away with the antenna down low, but you WILL see the bouy in the fog a LOT closer to the boat as you, hopefully, pass it. Traveling at Mach 1, I'd understand having more range. But, traveling at 6 knots I'd rather see that target two boatlengths off the port bow with a lower-down antenna....wouldn't you? The downsides of the large unit is almost double the cost (a $1000 premium on the RayMarine list) and a much larger dome (an issue for those trying to hide the dome from the jib). I'm tired of changing out pot metal Raymarine antenna pods. There's gotta be a way to build a $2000 radar transceiver that isn't made out of the same materials as the window winder in a '97 Ford pickup. The damned chassis it's all mounted in is made of ZINC!! Idiots.... Look inside for yourselves! Don't trust me. Unscrew the 4 little flathead screws and take the top of the dome off. Do it on that boat down the dock and see if it's wet inside! Furuno? Anyone had water destroy a Furuno radar dome?? |
#26
|
|||
|
|||
rhys wrote in
: Agreed, and I know what you are getting at. But if seas are flat, wind is calm, and you are on a misty seaway at dusk/dawn motoring at five knots under autopilot, I can see where a trawler or small frieghter doing the same on a reciprocal course would be nearly invisible to you simply due to the fact that your radar's proximity alarm or "range guard" or whatever they call it would not go off until the ship on the collision course was on top of you...solely due to the mizzen placement. If the radar antenna were a point source of RF out and back, this might be true. But, it's not a flashlight. The flat panel PC board planar array of the 2KW Raymarine dome is about 2' wide. The whole panel radiates and receives RF, so it's like having a set of "eyes" on the mizzen that are 2' apart. Could you see around the mainmast to all targets, the mainmast being 20' away from you with this "eye" arrangement? Yes, it works, even on small bouys 3 miles away. I've swung the boat through each degree very slowly to see if the bouy I could see off to the side had a blind spot dead ahead. It didn't. The panel isn't a point source like a flashlight. It's more like a 2' diameter floodlight shining past the mast, illuminating the target dead ahead, but probably with some loss of efficiency. |
#27
|
|||
|
|||
rhys wrote in
: Now, if I can just figure out how to put a windvane AND davits behind a mizzen mast....G R. B&G Pilot has "wind mode" to track the wind with the autopilot. Works great in that mode, too. No cure for the davits if your mizzen boom is too low..... |
#28
|
|||
|
|||
"Larry W4CSC" wrote in message Ah, but you have another problem in the fog. The higher the antenna, the further away the target will disappear as the target approaches the boat! You won't see the bouy 8 miles away with the antenna down low, but you WILL see the bouy in the fog a LOT closer to the boat as you, hopefully, pass it. Traveling at Mach 1, I'd understand having more range. But, traveling at 6 knots I'd rather see that target two boatlengths off the port bow with a lower-down antenna....wouldn't you? I have to wonder how serious a problem this really is. For instance, if I can run between two buoys spaced 300' with a scanner that's over 100' in the air and watch them pass down my side, how much difference can there be with a small boat and a scanner placed 30' up, unless you are totally crowding the buoy to one side (not good). Also, by that point, if you lose sight of the buoy, you should have all ready changed your concentration to some new point or reference, ahead. otn |
#29
|
|||
|
|||
On Tue, 15 Feb 2005 04:44:49 GMT, Larry W4CSC wrote:
Furuno? Anyone had water destroy a Furuno radar dome?? OK, crap construction drives me nuts, particularly when it's something (like a radar) which MUST spend its working life out in the elements. Assuming the radar itself isn't absolute crap...like that "Mars Bar" radar the Brits made 25 years ago, say...what is *your* radar of choice for durability? 'Cause once I go up the mast, I don't want anything short of a hurricane to cause damage to that radome... My buddy swears by his old Kodan CRT unit, but he's got a big ketch and more room and power than most people to play with. The thing is a toaster-sized box bolted to his coaming, and it takes skill to use it, but if you can learn that skill, it's accurate as hell. R. |
#30
|
|||
|
|||
On Mon, 14 Feb 2005 14:38:03 -0500, Jeff Morris
wrote: Does that sum it up? Yup. After sailing a sistership with the radar mounted high on the mast, I mounted mine below the baby stay, and never regretted it. Good. Thanks. One day I hope to use this information wisely. Reason I'm asking is that steel ketches look good to me on a number of levels. Now, if I can just figure out how to put a windvane AND davits behind a mizzen mast....G The windvane should go high on the mizzen, as on my friends boat: http://www.sv-loki.com/Moonshadow/Pg22.jpg Note that the davits are behind, and also serve as a good place for solar panels. Agreed, but I didn't mean windvane as in wind generator, but as in "mechanical self-steering" like this: http://www.voyagerwindvanes.com/ I can't determine how THAT would work on a ketch, with or without davits. R. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
sailing sim; need opinions | General | |||
Orion 27 Opinions? | Cruising | |||
Opinions on P&H Orca??? | Touring | |||
West System v SP System resins - opinions wanted | Boat Building | |||
sailing sim; need opinions | ASA |