Home |
Search |
Today's Posts |
#1
|
|||
|
|||
engine help required
ive got an evinrude 35 3 cylinder, power tilt ect. i had a problem today with it, that when i put it into reverse it went forward instead of backwards which caused me to nearly take the front off my boat and another, now ive only got forward gears. and when its in neutral now, the engine starts ok, but the prop turns. any reason why this should suddenly developed this fault any reason why it should only go forward when i put it into reverse ? i had a problem five minutes earlier, where it would rev but not go anywhere, not sure if that has any bearing on it? but that seemed to clear its self. many thanks richard rich ® |
#2
|
|||
|
|||
engine help required
ive got an evinrude 35 3 cylinder, power tilt ect. i had a problem today
with it, that when i put it into reverse it went forward instead of backwards Rich... Check the trunion of the cable at the engine (the portion of the cable that clamps at the engine). There's a possibility that it was not secured properly and has slipped out of the clamping area. Joe (30+ Years With OMC) |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Volvo 4.3 Engine Rebuild | General | |||
power vs sail | Cruising | |||
Evinrude FICHT beats out Yamaha in JD Powers survey | General | |||
Engine News from Genmar | General | |||
Usage of motoroil | General |