| Home |
| Search |
| Today's Posts |
|
#34
posted to rec.boats,alt.autos.ford,alt.autos.chevy,alt.autos.chevrolet
|
|||
|
|||
What engine is this?
Tom wrote:
yup. sbc, reverse mount, and it is probably in a criss craft boat also. 28 ft 1970s SlickCraft. Rob "Frank from Deeetroit" wrote in message ... "trainfan1" wrote in message news  Steve Barker wrote: http://i17.photobucket.com/albums/b7...c/IMG_0174.jpg http://i17.photobucket.com/albums/b7...c/IMG_0175.jpg the 429/460 has valve covers about twice as wide as these and more than 4 bolts in them. These valve covers are small block chevy. Sure looks that way. Did Grey Marine ever use Chevrolet heads on a proprietary block? This would be the only way to get the distributor drive gear into the front of the engine as I see it. That distributor is right where they are on the FE blocks. I can't think of any common wide block that shares bore spacing &/or bolt patterns with the SBC. Anyone? Rob Looks like a smallblock chevy that is installed with the front of the engine facing to the rear of the boat. The water pump and belts look like they are mounted on the back of the engine and the drive shaft would be connected to the front of the engine. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Nanni Diesel Engine Problems | General | |||
| rough engine intermittent | General | |||
| Engine coupler | General | |||
| Warm engine stalls at idle. -LONG | General | |||
| Visiting my new engine! | General | |||
Threaded Mode
