F.H. wrote:
trainfan1 wrote:
F.H. wrote:
Tim wrote:
On Jun 16, 12:27 pm, trainfan1 wrote:
Tom Adkins wrote:
Frank from Deeetroit wrote:
"trainfan1" wrote in message
news Steve Barker wrote:
http://i17.photobucket.com/albums/b7...c/IMG_0174.jpg
http://i17.photobucket.com/albums/b7...c/IMG_0175.jpg
the 429/460 has valve covers about twice as wide as these and more
than 4 bolts in them. These valve covers are small block chevy.
Sure looks that way.
Did Grey Marine ever use Chevrolet heads on a proprietary
block? This would be the only way to get the distributor drive
gear into the
front of the engine as I see it.
That distributor is right where they are on the FE blocks. I can't
think of any common wide block that shares bore spacing &/or bolt
patterns with the SBC.
Anyone?
Rob
Looks like a smallblock chevy that is installed with the front of
the
engine facing to the rear of the boat. The water pump and belts
look
like they are mounted on the back of the engine and the drive shaft
would be connected to the front of the engine.
Aaaahhhhh, for reverse rotation.
The hard way.

It's easier actually to run the engine backwards.

But this is a good explanation, except again the pics are too small to
see if that is a timing cover or a bell housing(starter & all on
flywheel) behind the water pump.

Rob- Hide quoted text -

- Show quoted text -



Well, not really. The reason Chris Craft did that was to have the
flywheel to the front of the boat, so they could get a lower profile,
and clearence for the angle of the engine, seeing it was hooked
directly to the trans, and the prop shaft were all in line with no u-
joints or carrier bearings. Or, thats the way it was described to me.

For most newer boats that in line set up is not important. Most
everyone now days uses u-joints and a drive shaft.

What size boat are you talking about?

All the Tournament, Tournament style, & Wakeboard inboards, direct &
V-drive, have no u-joints.

Rob

My last boat was a 24' Day Cruiser with a 460 Ford and a Berkley Jet
Drive. The jet was connected to the engine via a drive shaft. Before
that I raced flat bottoms. Never saw one without a driveshaft
connecting the enging to the V-Drive. In fact, most of the driveshafts
were fairly long, by that I mean 3' or so. Boats like this:

http://img141.imageshack.us/img141/9705/claimzl2.jpg

All the Tournament, Tournament style, & Wakeboard inboards, direct &
V-drive, have no u-joints. Just shafts.

Rob