Home |
Search |
Today's Posts |
|
#1
![]()
posted to rec.boats
|
|||
|
|||
![]() I doubt if anyone is making original fuel tanks for a 1970s boat. And I doubt if there would be an original one anyplace that has never been used (overstock). A 1978 Commander is not exactly a vintage boat. And were only talking about a fuel tank here; something that is out of site. If a welder can make a new one that has the same dimensions and look as the original...why not? The tanks are both located under the bed platform in the master suite in the rear of the boat. If I have to replace one I might as well replace both at this point. That sounds logical. I have a 1958 22' Chris Craft Sea Skiff. Very different boat, but I too am thinking of replacing the fuel tank. Ours is steel and not tooooo badly rusted inside. After running probably 30 hours with a small filter is was a bit clogged. Not so bad as we noticed an performance change...but enough that I can see rust particles in the small filter. Even on this "classic" boat that we've lovingly restored and want to be as close to orginal as we can, I have no problem with the idea of a local welder making a new tank. (Other than the price he wanted). Good Luck, Gary |
#2
![]()
posted to rec.boats
|
|||
|
|||
![]()
Guys, you can find quality replacement tanks on Ebay. Aluminum,
Fiberglass, or plastic. New, and used. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Yacht water storage links -Mic | Cruising | |||
care of aluminum tanks | Boat Building | |||
(non-political) comments on fuel economy and technology | General | |||
Gas Hog Cars, same phenomenon as boats | General | |||
Older FRP gas tanks may be at risk with ethanol gas formulations | General |