Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
electric marine hot water heaters
Well,
Finally sold the old boat, and have now devoted my spare time to preparing my new project boat for launch into the remainder of the Ohio summer. As my first order of business, I hooked in shore power and started up systems. Refrigerator? Check. Stove? Check. Outlets? Check. I then turned on the water pressure and ran the antifreeze out of the lines. I then started filling the tank (while still running the faucets). Once the tank was filled. I turned on the hot water tank, which immediately tripped the main breaker. I noticed the polarity indicator, flashed before tripping the main. Tried several times with all other systems powered off. Same results. Any ideas? Never having a hot water system, am I overlooking something obvious? Does this system need to be bled or reset at the water heater? Could it be the polarity of the power, even though everything else was working, and the polarity light does not flash until the tank is turned on? Any help or suggestions will be appreciated. Bob Dimond |
#2
|
|||
|
|||
electric marine hot water heaters
Electric elements do "rot out" and expose the nichrome wire to the water. The
grounding/bonding will cause the breaker to trip if you have a lot of minerals in the water. I would suggest removing them and giving them a quick look. If they show signs of cracks or corrosion, replace them. They are cheap. This can be exacerbated by buildup of those minerals at the bottom of the tank. If the bottom element can't "breathe" it will quickly burn out and there is plenty there to short it to the tank. I have a piece of 1/2" CPVC rigged up to fit on my wet/dry vac to suck this stuff out. OT ... has anyone used engine heat, via a double isolation heat exchanger to heat water? That sounds like a "free" way to do it if you are running. |
#3
|
|||
|
|||
electric marine hot water heaters
|
#4
|
|||
|
|||
electric marine hot water heaters
Not sure what you mean by a double isolation heat exchanger
A double isolation exchanger is one with an intermediate fluid between the potable water and the heating water. That way a single failure will not contaminate your water. It is usually used any time the heating fluid is a glycol mix. |
#6
|
|||
|
|||
electric marine hot water heaters
I think these systems are primarily in sailboats, to have hot water for
dishes and showers while at anchorage. Just like refrigerators that run off of an engine mounted compressor. Bob Dimond In article , Wayne.B wrote: On 14 Jun 2004 19:47:36 GMT, (Greg) wrote: A double isolation exchanger is one with an intermediate fluid between the potable water and the heating water. That way a single failure will not contaminate your water. It is usually used any time the heating fluid is a glycol mix. =================================== Assuming you don't drink the hot water, a simple check valve in the cold water supply line will suffice. I've never seen a boat with the arrangement you describe, but anythings possible I suppose. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Just a few names... | General | |||
Habbi's gearcase full of water | General | |||
Electric Trailer Brakes in Salt Water - Am I Nuts? | General | |||
Where to find ramp stories? | General | |||
Hooking up flush muffs...no water coming out of discharge (outboard) | General |