Home |
Search |
Today's Posts |
#1
|
|||
|
|||
1954 Evinrude 25hp Wiring
Just acqired a 1954 Evinrude 25hp outboard with no spark at the plugs.
The wiring harness hanging from the engine has 4 wires. 1) Positive starter lead, 2) ground lead, 3) wire conecting to the choke solenoid, 4) wire connecting to a gear that has a cable attached to it that goes up under the flywheel (either timing adjustment or linkage to the carb). My question is ... Do either wires 3 or 4 needs to be connected to something to complete the circuit for the points to send current to the plugs? I attached starter lead to positive and ground lead to negative and starter spins right away, but no spark. Thanks for the help. kj |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Evinrude 25 hp problem | General | |||
evinrude 2+4 & 2 stroke oil question | General | |||
Battery Disconnect Switch (wiring) | General | |||
evinrude 4 HP 2 cyl runs rough | General | |||
72 Evinrude 25HP Troubles | General |