Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
I accept that I did indeed need another coffee before my reply yesterday.
And at one point I said "outdrive" when I meant "trim tab," for example. So, everyone agree on this? Boat pulls to port. Want to have it self-steer more to starboard (to go "straight"). Require swinging (trailing edge of) outdrive to starboard. That requires turning trailing edge of trim tab to port. That is _clockwise_ when viewed from above - I am going to be stubborn about that. Would a schematic help? Charles ==== Charles T. Low - remove "UN" www.boatdocking.com/BDPhoto.html - Photo Contest www.boatdocking.com www.ctlow.ca/Trojan26 - my boat ==== |
#2
![]() |
|||
|
|||
![]()
Nah..no schematic needed here.
Boat goes to Port... You want it to go straight.. Point the tab to Port. OK here. -- RichG http://groups.msn.com/CarolinaSkiffOwners "Charles T. Low" wrote in message ... I accept that I did indeed need another coffee before my reply yesterday. And at one point I said "outdrive" when I meant "trim tab," for example. So, everyone agree on this? Boat pulls to port. Want to have it self-steer more to starboard (to go "straight"). Require swinging (trailing edge of) outdrive to starboard. That requires turning trailing edge of trim tab to port. That is _clockwise_ when viewed from above - I am going to be stubborn about that. Would a schematic help? Charles ==== Charles T. Low - remove "UN" www.boatdocking.com/BDPhoto.html - Photo Contest www.boatdocking.com www.ctlow.ca/Trojan26 - my boat ==== |
#3
![]() |
|||
|
|||
![]()
RichG,
I think we agree. By "point the trim tab to Port," you mean the trailing edge, which is the way I describe it too. ==== Charles T. Low - remove "UN" www.boatdocking.com/BDPhoto.html - Photo Contest www.boatdocking.com www.ctlow.ca/Trojan26 - my boat ==== "RichG" wrote in message m... Nah..no schematic needed here. Boat goes to Port... You want it to go straight.. Point the tab to Port. OK here. -- RichG |
#4
![]() |
|||
|
|||
![]() "Charles T. Low" wrote in message ... That is _clockwise_ when viewed from above - I am going to be stubborn about that. Would a schematic help? Charles My brain is starting hurt. I think you are correct and I have it exactly backwards. I'll be going out sometime this week and I'll try it out on my boat. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Trim tabs | General | |||
trim tabs | General | |||
Trimming the drive | General | |||
Setting Trim Position and Trim Limit Switches | General | |||
Power Trim | General |