About Us

Mr. Luddite[_4_]

On 8/3/2018 4:19 PM, Wayne.B wrote:
On Fri, 03 Aug 2018 13:55:25 -0400, wrote:

On Fri, 03 Aug 2018 06:48:47 -0400, Wayne.B
wrote:

On Thu, 2 Aug 2018 20:17:14 -0700 (PDT), wrote:

I have a force 125hp. Im thinking about putting it on a 1989 searay. Is there anything holding me back from doing so

===

My advice would be to check with the manufacturer.

http://www.searay.com/page.aspx/pageid/162289/Owners-Resources.aspx#Resources

I suppose he could start by looking at the capacity plate on the boat.
Since he didn't say what size it was, a 125 might be too heavy.
I would be more concerned about the condition of the motor. Force had
lots of problems. I am a little surprised that one is still around and
running.

===

I assumed from his question that either he doesn't know about capacity
plates or the boat doesn't have one for some reason. Do you know what
year they became required?

U.S. Coast Guard Federal Boat Safety Act of 1971. Boats less than 20
feet powered with an inboard, outboard, or stern drive engine
manufactured after November 1, 1972, must display a capacity plate
defining the safe load limits.

The "capacity" is number of people or total pounds including gas and engine.

Max HP for engines applies only to boats powered with outboards.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode