Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
Johnson outboard problem
I believe coincidences are rare. My suspicion is that when they worked on the charging problem, they removed the flywheel (am I correct to assume this would be done?) and never tightened it afterwards. Would a loose flywheel cause the problem I've experienced? Could running with the flywheel loose damage the fit where it can't be tightened properly, and the problem continues? If the flywheel was loose enough, there is a possibility that it wasn't seated in the keyway. The flywheel could cause the engine to be out of time. If so it would or could be retarded enough to not get full power. Leanne |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Removing lower unit from 40 hp Johnson outboard - Help? | General | |||
Newbie Q - old Johnson 40 problem | General | |||
what just happened? outboard problem | General | |||
back with a problem now | General | |||
Johnson 70 outboard. Smoke at idle | General |