wrote in message
...
On Thu, 8 Jul 2010 11:10:28 -0300, "YukonBound"
wrote:



"W1TEF" wrote in message
. ..
On Thu, 8 Jul 2010 09:59:27 -0300, "YukonBound"
wrote:

Thanks to some dogged investigating, I've solved my starter problem and
all
works well.
I won't bore you with the details........ but after 'the fix' was made,
the
starter jumped up and threw that flywheel around like a champ.

So what was it?

Ok.. since you asked...
This solution was in the back of my mind from the start, but I didn't want
to try anything for fear of causing problems.
I was able to turn the bendix toothed gear by hand and one way it would
raise up on a helix to the flywheel so I felt nothing was seized there.
When I pressed the starter I noticed that the bexdix was spinning
clockwise... same way as the flywheel did when I pulled on the cord.
This didn't seem right so I took a closer look at how the Minn Kota prop
spun when I put in in forward & reverse.
You guessed it...the opposite way from what you would expect.
I had assumed that the cables leading to the battery posts were like your
normal 14-2 household wiring.
That is..... black hot & white neutral. It was the opposite.... the white
wire belonged on the + post and black on the - post.
I couldn't remember how it was connected when I re-installed the battery
...and with a 50% chance of getting it right...i didn't.
I'll mark or apply red tape to that white wire so I don't make that
mistake
again.



I hate to be the bearer of bad news but you probably blew the
rectifier and you may have damaged the charging winding of your
stator. If you have a meter, see if you have 14-15v on the battery
when you are at speed.

What was there as part of the charging system was removed two years ago.
A couple screws vibrated loose and spun around damaging components. i
wasn't using the charger... so didn't want to replace the damaged parts.