About Us

HK

Don White wrote:
"jim78565" wrote in message
...
wrote:
On May 10, 6:44 am, jim78565 wrote:
wrote:
On May 9, 7:54 pm, Rick Suds wrote:
Hi , I have a 1998 30 foot Cruisers , The gas gauge only reads half
full
after I fill the tank . This boat has 2 tanks and 2 gauges and only
the
one gauge is reading correctly .I have cleaned the contacts on the
tanks and switched the gauges and I still have the problem ??
Rick
--
Rick Suds
Sounds like the float is " gas-logged ", worn -out, or the ohm value
is out of whack.Could be a bad ground on the float, or the lead FROM
from the tank where it connects to the ground buss. Just my guesses.
Good guesses from slammy. Ground the sender lead. If the tank reads full
replace the sender. Make sure you follow the instructions.
I'm a plethora of useless information. I listen to people who know ,
and store facts....
Are there 2 of you posting under the same handle? I am detecting different
writing "styles" from you. (for the lack of a better way to describe it)

If someone acts civil towards him...he responds in kind.
What's so hard to understand about that? After all...it's the 'Canadian
way'.

Just got a card from my father in law, who was up in western Canada last
week for his annual 10,000 mile train vacation. He likes Canadians, too,
and claims they are much more "relaxed" than the folks he encounters
stateside.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Yamaha Fuel Management Gauges	Graham	General	40	July 5th 08 02:10 AM
New Gauges - which?		General	5	August 21st 05 10:44 PM
Any way of testing dash board gauges?	g	Boat Building	3	June 27th 04 11:48 PM
Any Way of testing dash board gauges?	g	General	1	June 27th 04 04:07 PM
Computerized gauges	Paul	Cruising	22	November 28th 03 01:34 PM

Menu

About Us