Home |
Search |
Today's Posts |
#2
![]() |
|||
|
|||
![]() "Jon Gauthier" wrote in message ... I haven't fired up EZNEC yet, but I was wondering how a standard 3dBi marine whip would perform on the 2m ham bands. Since the marine frequencies are 156.050-157.425 MHz, what could I expect at 144-148 MHz? If it won't cut it, then does anyone have any recommendations for a dual-band antenna (commercial or home-built)? Jon You could expect 3:1 or worse SWR unless you found a "dip" at certain frequencies in the 2 meter ham band. I believe Morad makes a 2 meter version of one of their marine antennas, however, their web site says "under construction" when I checked it today. I usually use a Larsen (Radiall) antenna on a boat for 2 meter ham band or VHF high band public safety frequencies. Do not try using a ham rig and a marine VHF radio on the same antenna, as sooner or later you will accidentally end up transmitting into the other radios receiver. Modified ham rigs on the marine band are illegal. 73 Doug K7ABX |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
2005 West Marine catalog announed | General | |||
Just a few names... | General | |||
Essentials of a Marine Boat Alarm System | Electronics | |||
paradise cove trip | ASA | |||
The same people | ASA |