Home |
Search |
Today's Posts |
#2
![]() |
|||
|
|||
![]()
On Sat, 20 Dec 2003 19:39:04 +0100, "Ric" wrote:
I have just bought a couple of Delphi Freedom marine deep cycle batteries for my service bank. Is there a recommended minimum voltage below which one should not discharge? Also, if the nominal capacity is (say) 100Ah, is that measured between standard voltages or is it measured from a nominal full charge (with full charge voltage dependent on the charging system) until totally discharged - ie 0v? Or is there a standard "never go below" voltage which manufacturers use? 10.5 volts is considered "fully discharged". For best results, it is generally recommended that you should only discharge a battery to 50%, so you should only take 50 AH from a 100 AH battery. -- Peter Bennett, VE7CEI new newsgroup users info : http://vancouver-webpages.com/nnq GPS and NMEA info: http://vancouver-webpages.com/peter Vancouver Power Squadron: http://vancouver.powersquadron.ca |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Another deep cycle battery question...>>> | General | |||
Batteries and baby bottles | General | |||
charging deep cycle trolling battery with truck | General | |||
Deep Cycle vs. Trolling Batteries | General | |||
Advice please: starting problems | Electronics |