Home |
Search |
Today's Posts |
#4
|
|||
|
|||
Ext spkr for VHF Radio
Bill,
It sounds like your wiring is wrong. Without your switch connected, First check to make sure that the common wire on the stereo is really at ground on the radio. Next check to see that one of the wires out of the marine radio is at ground on the radio. If both have those leads grounded on each unit then you can do what you want with the double pole double throw switch. Leave the common speaker leads grounded to the common lead on the stereo. Place each of the other speaker leads on the CENTER poles of the switch. (one on each pole) On one end of the switch place each of the leads from the stereo. Now when the switch is in one position the speakers will be hooked as they normally were to the stereo. In the other position of the switch one lead of each speaker will be disconnected from the stereo. In that position of the switch the speakers will now be hooked to the opposite end of the switch. You can hook the ungrounded lead of the marine radio to one of the poles on the opposite end of the switch from where the stereo radio is hooked. The grounded speaker lead from the marine radio would get connected to the grounded connection of the stereo and speaker ground junction. Now with the switch in the marine radio position the stereo is disconnected on both channels and the marine radio is connected to ONE of the speakers. If you want both of the speakers to be connected to the marine radio place a jumper wire between the two terminals on the end of the switch that the marine radio is connected to. (one of those would have been the only unused pole on the switch) Regards Gary On Thu, 18 Dec 2003 13:31:24 -0800, "Bill Andersen" wrote: The stereo has a separate output and ground for each speaker. The VHF has a built-in speaker and a outlet for an external speaker jack. The DPDT switch has 6 posts, I cut one of the wires from the stereo to each speaker and ran them to the left and center posts of the switch so, when the switch is to the left, the stereo is connected to the speakers. I ran a wire from the external speaker jack of the VHF to the right and center posts of the switch so, when the switch is to the right, the VHF is connected to the speakers. "Larry" wrote in message .. . On Thu, 18 Dec 2003 08:50:30 -0800, Bill Andersen wrote: I want to use the two stereo speakers of my boats AM/FM/Cassette Player for my VHF radio. I wired both radios to a Double Pole Double Throw switch. The AM/FM/Cassette Player works, but the VHF radio volume is so low I can barely hear it. The specifications for both radios state 4-8 ohm speakers. The AM/FM/Cassette Player states 14 watts RMS maximum stereo power, the VHF radio states 4 watts audio output. Is there anyway I can use the stereo speakers for both radios? If not, will the VHF radio have enough power to hear it if I add two of the mini-speakers designed for it in the rear cockpit area? I'm not sure how you wired it as the VHF radio most likely has a single speaker output and the stereo has two outputs (right and left) and may share a common ground. You can use the stereo speakers for both radios, but you should turn off whichever radio is not connected to the speakers to avoid blowing out the audio section. If it were me, I'd add a SINGLE remote speaker to the VHF radio, making sure it is plugged into a connection designed to power a speaker. -- Larry email is rapp at lmr dot com |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
USING GPS WITH VHF RADIO (DSC) HELP | General | |||
VANISHED (stolen?)- a new (and unique) 57' Beneteau | Cruising | |||
Icom 402 radio woes..or is it my antenna system? | Cruising | |||
Radio for Newbies...... | General |