Home |
Search |
Today's Posts |
#8
![]()
posted to rec.boats.cruising
|
|||
|
|||
![]()
Bruce in Bangkok wrote in
: It seems to be more a matter of size as the BIG engines are all low RPM engines that at lower RPM while lower power engines are usually higher speed engines. for example, the Emma Mursk uses a 108,920 H.P. @ 102 RPM engine and probably doesn't require a reduction gear, while a smaller ship might use a 5,800 Hp @ 600 RPM engine with reduction gear. Bruce-in-Bangkok (correct Address is bpaige125atgmaildotcom) I've stood atop the 7-cylinder, 2-stroke beast that powers SeaLand "Performance". It's 38,800hp at 102 RPM and burns 75 tons of heavy oil boiled in the exhaust stack before injection to thin it at about 76 RPM, her econocruise speed give or take the load, of course. The massive flange aft of the engine is directly coupled with huge bolts to the screwshaft going out to her single screw. If you were standing on a platform at the base of a blade, you could extend your hand about halfway up that blade towards the hub. I can't remember how many blades were in the picture, sorry. The engine is computer controlled so noone has to sit and baby sit it in the air conditioned control room where the massive power panel is also located for the large array of 3-phase 408?V diesel gensets power that are located in a compartment under the main shaft under the rudder gear. The day I was there they were about half loaded for sea and the panel said they were generating a little more than half a megawatt to keep the fruit cool and the frozen food frozen in the freezer containers. They got plenty of AC power! If the computer sees something it doesn't like on an array of engine sensors in each cylinder, it pages the duty engineer wherever he may be to come look. If something really bad were to happen, the computer would shut her down to prevent further damage and all hell would break loose. Captain Larry, a ham friend of mine, is one of her two masters and he says he never gets tired of playing with her...(c; Forward or reverse she will run either way, being two stroke with no valves. Big blowers ventilate her when the ports are open at BDC before the next 5 foot trip up the cylinder, injection and explosion drives her down again. Oh how I wanted to go to sea with them to see it run and hear that thumping for myself. Captain Larry claims he can do an emergency stop from econocruise speed in NEARLY 2.5 MILES!....which is also about her "turning circle" in flat water. Not bad considering she's 980' long. Standing on the bridge, I commented, "Well, at least you won't get hurt in a front end collision. Hell, you're half a mile back from the accident!" A color TV system let's you watch for those damned crab pots over the bow, but I doubt they worry over them like we do....(c; Air start....either way. Very exciting. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
generator question | General | |||
Generator question | General | |||
Marine generator question (cost?) | General | |||
Generator question | General | |||
Generator Overheating Question | General |