Home |
Search |
Today's Posts |
#10
|
|||
|
|||
Folding Cabin table??
My objective is to be able to rig or unrig the table with "a single motion"
without need to fumble with bits and pieces. I don't plan to have it down unless there is a need for it yet the storage against the bulkhead should also be neat and not look like an stored ironing board.. If I can work out a neat leaf folding system I will become the face of a cabinet on the bulkhead. I've seen one system like that but could never make out the hinge details from the photos. Yes. I love my open area but haven't been in open water yet.. I'm sure I will want something to grab since the cabin trunk grab rails are at least 60 inches apart and the passage fwd/aft isn't down the middle.. I can't put full grab rails in the overhead because of head clearance. I may just run a 1/2"X1 1/2" slat type just under the deck beams.. Just thinking out loud. Steve s/v Good Intentions |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Varnishing Cabin Sole | Boat Building | |||
FS: Force 10 Cozy Cabin Heater w/ heat exchanger | General | |||
FS: Force 10 Cozy Cabin Heater w/ heat exchanger | Cruising | |||
support for a table? | Boat Building | |||
Hunter 37.5 Salon Table Collar | Cruising |