Home |
Search |
Today's Posts |
|
#1
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
MANY Thanks to Richard Kinch and Bryan Combs for some great replies, it
was clear that they understood I am only going down 6 to 8 feet and just need a little compressor, similar to those used for small paint sprayers. I will also have 30A dock service to plug into. This was my first post and participation and, while I love a little humor as much as the next guy (see my book The Baja Bash), it was a little hard finding the worthwhile posts while sifting through others from people who clearly feel a need to reply to anything and everything, under the assumption that they know all and should therefore pass on their pearls of wisdom. |
#2
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
BajaJim wrote:
MANY Thanks to Richard Kinch and Bryan Combs for some great replies, it was clear that they understood I am only going down 6 to 8 feet and just need a little compressor, similar to those used for small paint sprayers. I will also have 30A dock service to plug into. This was my first post and participation and, while I love a little humor as much as the next guy (see my book The Baja Bash), it was a little hard finding the worthwhile posts while sifting through others from people who clearly feel a need to reply to anything and everything, under the assumption that they know all and should therefore pass on their pearls of wisdom. Jim, I believe that the warnings you received about "oil" based compressors are based on the concern that you might be exposing yourself to what are admittedly small amounts of toxins but over long periods of time, all while working underwater - an environment where one would like to avoid encountering breathing issues. To compound this further you will be most likely be exerting yourself enough to raise your respiration rate which would increase any toxin absorption rate. Also, because of the "partial pressures" of breathing gases in increased atmospheres, the percentage of toxin absorbed by your body goes up dramatically as you go deeper. If you can avoid using an oil based compressor I would strongly suggest doing so, especially since inexpensive alternatives exist. Cheers, Robb |
#3
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
Good post Robb.
The toxins are minute until the compressor pistons rings get worn (or do not fit right from the beginning) and allow oil to enter the cylinders. With the heat that's generated by compressing air, the oil will partially burn and create carbon monoxide which coats the red blood cells and prohibits the transfer of oxygen to those cells and further to the other cells in the body. Absolutely right about the oil free compressor! MMC "AMPowers" wrote in message ... BajaJim wrote: MANY Thanks to Richard Kinch and Bryan Combs for some great replies, it was clear that they understood I am only going down 6 to 8 feet and just need a little compressor, similar to those used for small paint sprayers. I will also have 30A dock service to plug into. This was my first post and participation and, while I love a little humor as much as the next guy (see my book The Baja Bash), it was a little hard finding the worthwhile posts while sifting through others from people who clearly feel a need to reply to anything and everything, under the assumption that they know all and should therefore pass on their pearls of wisdom. Jim, I believe that the warnings you received about "oil" based compressors are based on the concern that you might be exposing yourself to what are admittedly small amounts of toxins but over long periods of time, all while working underwater - an environment where one would like to avoid encountering breathing issues. To compound this further you will be most likely be exerting yourself enough to raise your respiration rate which would increase any toxin absorption rate. Also, because of the "partial pressures" of breathing gases in increased atmospheres, the percentage of toxin absorbed by your body goes up dramatically as you go deeper. If you can avoid using an oil based compressor I would strongly suggest doing so, especially since inexpensive alternatives exist. Cheers, Robb |
#4
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
MMC wrote: Good post Robb. The toxins are minute until the compressor pistons rings get worn (or do not fit right from the beginning) and allow oil to enter the cylinders. Absolutely right about the oil free compressor! Thanks for adding your ideas here. Finally some advice based on training, experince, and still here to give it. Unlike the other past posts that simply said, "Ive been doing it this way for years and never had any porblems." Here is my question for you MMC: A few comments earlier in this discssion I described a hand pump that supplied diver air to about 20'. Did you ever run into anything like that in the service? They were a little (maybe 25 lbs.) two cylinder thing with a five foot handle that a person push-pulled too operated the pump. The guy who made the new prototype said he got the idea from one he saw in an old USN Dive Manual. Thanks, Bob |
#5
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
Salty Bob,
Man, that is an old set up! I remember pictures like that from the period before those wiley divers hooked a new fangled gasoline engine to a compressor! The Navy used various models, without much change in design, of the Mk 5 hat from the 1840s to the 1980s. As I remember (got an old dive manual around here somewhere, hell if I know where) the handle was like on the old manual rail cars, you know the ones 2 guys would stand on and pump the handle from the ends, up and down for moving down a rail to perform maintanence? Didn't John Wayne have a rig like that in "Wake of the Red Witch"? As I remember a Mk 5 diver would be conscious for something like 6 minutes if he lost his air supply, so if the supply flow replaced the air in the suit every 2-3 minutes he'd be fine. Running a compressor like that directly to a hat or mask, would only require a 2-3 cfrm and about 15 psi over bottom pressure? Add depth and add cfm. MMC "Bob" wrote in message oups.com... MMC wrote: Good post Robb. The toxins are minute until the compressor pistons rings get worn (or do not fit right from the beginning) and allow oil to enter the cylinders. Absolutely right about the oil free compressor! Thanks for adding your ideas here. Finally some advice based on training, experince, and still here to give it. Unlike the other past posts that simply said, "Ive been doing it this way for years and never had any porblems." Here is my question for you MMC: A few comments earlier in this discssion I described a hand pump that supplied diver air to about 20'. Did you ever run into anything like that in the service? They were a little (maybe 25 lbs.) two cylinder thing with a five foot handle that a person push-pulled too operated the pump. The guy who made the new prototype said he got the idea from one he saw in an old USN Dive Manual. Thanks, Bob |
#6
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
MMC writes:
The toxins are minute until the compressor pistons rings get worn (or do not fit right from the beginning) and allow oil to enter the cylinders. With the heat that's generated by compressing air, the oil will partially burn and create carbon monoxide which coats the red blood cells and prohibits the transfer of oxygen to those cells and further to the other cells in the body. You are confusing heat and temperature, because compressing air does not generate heat. The existing heat is concentrated into a smaller volume, raising the temperature, but this does not rise to ignition at 90 psi. Perhaps you are thinking of scuba tank compressors at many 1000s of psi. If what you say were true, then working with compressed air in a closed shop would be even more hazardous, since the air is recycled over and over through the compressor as it is exhausted into the room. But there is no CO or oil vapor to be concerned with in those situations. Mineral oil is not toxic in itself. You are breathing oil-contaminated air all the time, over a cooking stove or around 2-cycle engines. No one thinks much of it, because it isn't a hazard. |
#7
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
: MMC writes: The toxins are minute until the compressor pistons rings get worn (or do not fit right from the beginning) and allow oil to enter the cylinders. With the heat that's generated by compressing air, the oil will partially burn and create carbon monoxide which coats the red blood cells and prohibits the transfer of oxygen to those cells and further to the other cells in the body. Richard J Kinch wrote You are confusing heat and temperature, because compressing air does not generate heat. Way big mistake..........! Please consult Charles Law The existing heat is concentrated into a smaller volume, raising the temperature, but this does not rise to ignition at 90 psi. Perhaps you are thinking of scuba tank compressors at many 1000s of psi. If what you say were true, then working with compressed air in a closed shop would be even more hazardous, since the air is recycled over and over through the compressor as it is exhausted into the room. But there is no CO or oil vapor to be concerned with in those situations. Mineral oil is not toxic in itself. Now that depend on where you are breathing a contaminated gas mix that includes Mineral Oil present. The term that MMC used is worth researching: Partial Preasure. You are breathing oil-contaminated air all the time, over a cooking stove or around 2-cycle engines. No one thinks much of it, Uhh. I do! because it isn't a hazard. Did I just bit on a troll? This has got to be a troll. If not........... for anyone wanting to breath compressed air please do not belive anything posted here. Bob |
#8
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
Bob writes:
You are confusing heat and temperature, because compressing air does not generate heat. Way big mistake..........! Please consult Charles Law Charles's Law relates pressure and temperature. Not heat. Learn the difference. |
#9
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
Richard J Kinch wrote: Charles's Law relates pressure and temperature. Not heat. Learn the difference. Dear Richard: Please explain the relationship between pressure and heat and temperature. I think temperature and heat might be similar. But how? That is BTU = Degrees Fahrenheit. So what is missing? We can get into a discussion about pressure-heat - volume when the sun is up. Ignorant Bob. |
#10
posted to rec.boats.cruising
|
|||
|
|||
Air compressor for hull cleaning
Richard J Kinch wrote:
MMC writes: The toxins are minute until the compressor pistons rings get worn (or do not fit right from the beginning) and allow oil to enter the cylinders. With the heat that's generated by compressing air, the oil will partially burn and create carbon monoxide which coats the red blood cells and prohibits the transfer of oxygen to those cells and further to the other cells in the body. You are confusing heat and temperature, because compressing air does not generate heat. Nonsense. The "compression of air", i.e. the volume change alone, does not change heat content(enthalpy), however mechanically "compressing air" always does. Any mechanism that compresses air does work on the system (consider all the frictional components), and that work is reflected in increased temperature and enthalpy. The existing heat is concentrated into a smaller volume, raising the temperature, but this does not rise to ignition at 90 psi. Ignition temperatures are not required, however, to generate volatilized oxidation components. CO is not likely to be an issue without ignition-high temps, but I'd just as soon not breath contaminated oil vapor. Perhaps you are thinking of scuba tank compressors at many 1000s of psi. If what you say were true, then working with compressed air in a closed shop would be even more hazardous, since the air is recycled over and over through the compressor as it is exhausted into the room. But there is no CO or oil vapor to be concerned with in those situations. Hardly the same context given the dilutional differences. A "closed" shop is *not* a sealed shop. Mineral oil is not toxic in itself. In the gut, no. In the lungs, yes. Coat your alveoli with it and see how long you last. The lungs have mechanisms for clearing particulates, but not oils. And let's not forget that the oil has lots of other charming things in it (like heavy metals from wear surfaces) by the time it gets to your lungs. You are breathing oil-contaminated air all the time, over a cooking stove or around 2-cycle engines. No one thinks much of it, because it isn't a hazard. Well, I'd suggest that most people think more about it than you do. And in most of those situations, you're getting particulates, not volatilized oil. You're also breathing through your nose, which is designed as a filter (i.e. impingement on mucosal linings of the nasal and sinus passages), which you will not be doing underwater, unless using a full face mask. Using an oil sealed compressor to supply breathing air is just stupid, unless you care nothing for your health. Keith Hughes |
Reply |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Cleaning the hull | Cruising | |||
Handy 35s5 Cleaning Tips | ASA | |||
Mouldy Old Boats and cleaning tip request! | General | |||
Cleaning Fiberglass | General | |||
Cleaning Fiberglass | Cruising |