I did that and followed up with heat from a hair dryer as I continued
to struggle with it. The diameter of the barbs on the fittings is 1
1/16" and the I.D. of the hose us a hair under 1". Lots of lube as
well.

I did learn one useful thing while sweating the hose on and off of the
heated steel pipe nipple to stretch it. If you twist the hose one
way, it gets smaller and tighter. Twist it the other way and it gets
larger. I'm using Shields VAC XHD Series 148 for now. Odor isn't as
much of a problem in our cold climate and I flush the system often.
If it goes bad, I'll replace it with Aussiegold down the road.

BTW the Marlon fittings fit this hose perfectly but the right ones
weren't in stock. If I had any idea what a struggle this would be, I
would have waited until I could order Marlon for everything.

--

Roger Long



"MMC" wrote in message
...
Roger,
After I wrestled (with a lot of cussing, and the application of
various
lubricants for the hose and me) with sanitation hose for years, a
friend
shared his recipe for this. I now heat a pot of water to a boil, and
dip the
end of the hose in the water, leaving it for just a few seconds. The
hose
softens enough to slide all the way on and once it cools, is there
to stay
and I've never experience any degradation to the hose caused by this
procedure. You might want to experiment with different in water wait
times.
MMC

"Roger Long" wrote in message
...
I'd been warned that the gray hose fittings from hardware stores
are
ridiculously oversize but I didn't realize that the nylon ones from
the marine store are also until after a lot of sweating and
cussing.
Even after working the hose onto a heated (gently) pipe of the same
diameter to stretch it, getting the hose on the nylon nipples was
at
the limit of feasibility.

Does anyone know the genesis or rational for this crazy situation?
Why
can't the nation the put a man on the moon produce hose fittings
that
fit hose?

--

Roger Long

No you won't. It looks like they're not going to make it any more. :-(