Home |
Search |
Today's Posts |
#11
|
|||
|
|||
Paul Schilter wrote:
Mike G I served on the USS Tripoli LPH-10, a helicopter carrier. It was about 600 feet long. Had just one engine. One time off the California coast we floated for about 12 hours while they worked on it. This was a brand new ship, I was part of the commissioning. This was around 1966. Perhaps that's why it's now mothballed. Paul Mike G wrote: There is a reason why the USN likes to buy it's jets with two engines. We can all mention incidents of single engine vessels breaking down with no "take home" capability, however in the ship department, there are far more single engine ships running around ... reliably .... than multi engine ones. Yes, there are advantages to multi engine/shaft vessels, but, especially with today's engines, for what most boaters are doing, one should should be sufficient if properly maintained .... especially if you have one of many "take home" possibilities. |
#12
|
|||
|
|||
Clearly I confused the issue by mixing two strokes with four strokes.
My inquiry was 1 or 2 engines. If both setups were 2 strokes, which would have a faster top end and why? Which would be more economical fuel wise and why? Which would be faster out of the hole? "Jim and Becky" wrote in message ... I want to order a new 26' walk around from a local dealer. It could come with a pair of 4 stroke 150's or one 2 stroke 300. What would be the characteristics of each set up? About all I know is that the pair weights 932 lbs, the 300 weighs 543. Lets leave initial cost aside. All engines are Yamahas. |
#13
|
|||
|
|||
On Sat, 9 Apr 2005 00:01:09 -0400, "Jim and Becky"
wrote: If both setups were 2 strokes, which would have a faster top end and why? Which would be more economical fuel wise and why? Which would be faster out of the hole? ========================================== Assuming equal horsepower, the single engine boat will be faster, primarily because of reduced drag and weight. Speed out of the hole depends a lot on conditions and prop selection. |
#14
|
|||
|
|||
In article , Paul Schilter
""paulschilter\"@comcast dot net" says... Mike G I served on the USS Tripoli LPH-10, a helicopter carrier. It was about 600 feet long. Had just one engine. One time off the California coast we floated for about 12 hours while they worked on it. This was a brand new ship, I was part of the commissioning. This was around 1966. Perhaps that's why it's now mothballed. Paul Mike G wrote: There is a reason why the USN likes to buy it's jets with two engines. LOL, Did my time,also in "66" as a Bosuns mate on an APA that was commissioned in 1942. We spent a lot of time drifting around. However, that's a ship with lots of snipes to fix such things, not a jet with no way to fix things if the engine flames out a long way from home. Take care -- Mike G. Heirloom Woods www.heirloom-woods.net |
#15
|
|||
|
|||
I have a 7.3metre (25foot) 'Whittley sea legend' sports fishing boat.
(I live in Western Australia)and I decided on twin motors and bought 135 Mercury OPTIMAX 2 strokes. I can't fault them. Fuel consuption has averaged 15ltrs per hour (thats 7.5 ltrs per motor)over the 3 years I have had the boat, but at a cruising speed of 25 knots I get about 22/25 ltrs per hour.(11/12.5 ltrs per hr EACH MOTOR)I reckon thats pretty good . Do you NEED 2 motors? Only when one fails..... and that happened to me 3 months ago, about 10 nautical miles offshore, in a 20/25 knot wind, with seas to 2metres and a 1.5/2 metre swell. Not a very good situation to be in if you only had one motor I can tell you. What happened was the that the 'thermostat' had **** itself, along with the impeller, and the engine overheated. Mmmmmm... However, I limped back to the mainland and into port with just the one motor... no worries. and I'm still alive to tell the tale. My advice is buy TWIN outboards...they are SAFER, and they are so much easier to manouvre in and out of the dock....oh yes, and did I mention...TWO MOTORS ARE SO MUCH SAFER THAN ONE...do you really need another reason? tomtwice, "Jim and Becky" wrote in message ... Clearly I confused the issue by mixing two strokes with four strokes. My inquiry was 1 or 2 engines. If both setups were 2 strokes, which would have a faster top end and why? Which would be more economical fuel wise and why? Which would be faster out of the hole? "Jim and Becky" wrote in message ... I want to order a new 26' walk around from a local dealer. It could come with a pair of 4 stroke 150's or one 2 stroke 300. What would be the characteristics of each set up? About all I know is that the pair weights 932 lbs, the 300 weighs 543. Lets leave initial cost aside. All engines are Yamahas. |
Reply |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Volvo 4.3 Engine Rebuild | General | |||
power vs sail | Cruising | |||
Evinrude FICHT beats out Yamaha in JD Powers survey | General | |||
Engine News from Genmar | General | |||
Usage of motoroil | General |