Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Engine Mounting Bolts
I am repowering twin crucaders. The lag bolts that are used to secure the
motomounts to the engine beds should I use stainless or galvanized? I heard the stainless are to hard and will snap due to vibration? I have the original Crucaders manual and state that either type of bolt may be used. I am open to suggestions. Thanks, Bill |
#2
|
|||
|
|||
Engine Mounting Bolts
"Bill" wrote in message ...
I am repowering twin crucaders. The lag bolts that are used to secure the motomounts to the engine beds should I use stainless or galvanized? I heard the stainless are to hard and will snap due to vibration? I have the original Crucaders manual and state that either type of bolt may be used. I am open to suggestions. Thanks, Bill Bill, before you snap good stainless you will probably strip out the wood in your engine beds. I've never had a problem with stainless, I've had them on several boats. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Volvo 4.3 Engine Rebuild | General | |||
Visiting my new engine! | General | |||
Evinrude FICHT beats out Yamaha in JD Powers survey | General | |||
Engine News from Genmar | General | |||
Usage of motoroil | General |