Hello all,

As a first time novice to fixing boats I have probably jumped into the deap
end but I like a challenge.

Just aquired a 17ft - 1/2 cabin Fishing boat / Cabin Cruiser (not really
sure of the exact term to use)

Wooden frame, Ply hull with Fibreglass coating. All looks good yet there are
a few of the ribs have to be replaced and also some sections of the ? rails
? (small strips on inside of hull running lengthwise) need to be replaced
as there is some dry / wet rot. The Boat had a few years of bad neglect yet
I ave taken it on as a project....

Most of the frame is quite solid... none of the fibreglass is cracked or
repaired in any areas... and the internal ply hull and keel (centre beem)
seem OK... no breakdown as far as I see...

Just want a few peoples opinions on what marerials I should use, wood type,
glue type, techniques, etc.... what should be done first?....

At this stage the boat is bare... no cabin (taken off), no decking (only bow
cover frame) and the intact hull....

Post your replies and CC email me as I don't get to check the newsgroups
that much.

Thankx

Chris Gerraty