Home |
Search |
Today's Posts |
#11
|
|||
|
|||
Looking for free boat plans...
"Miljenko" ) writes:
Already did it. I measured one old form and put it in AutoCAD14. Than little work about smoothering lines and rescaling to 6 mtr. All sections was printed 1:1 cut and covered with 3 layer of 4mm plywood+epoxy (90 degrees shift) and finally 1 ply of rowing. Of course, almost every strip line of plywood needed corections to best fit. I ALREADY BUILT 6 MTR. BOAT !!! Result is high quality, very nice little boat. Now I am ready for something bigger. See you on Monday. Bye. Miljenko. sorry I didn't read the original correctly -- ------------------------------------------------------------------------------ William R Watt National Capital FreeNet Ottawa's free community network homepage: www.ncf.ca/~ag384/top.htm warning: non-freenet email must have "notspam" in subject or it's returned |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
OT Hanoi John Kerry | General | |||
Where to find ramp stories? | General | |||
Dealing with a boat fire, checking for a common cause | General | |||
The best laid plans... we'd ignore -- a boat buyer's story | General | |||
Repost from Merc group | General |