Then look at http://www.dinghyshop.com/sunfish/bailer.html


"Glenn Ashmore" wrote in message
news:PKQ9f.39$ii.16@dukeread04...
"Jim Conlin" wrote in

Sunfish had simple bronze suction bailers.. I think they had some kind
of
check ball.

That is sort of what I am looking for. A low profile self bailer with a
check ball.

--
Glenn Ashmore

I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com

That looks like a winner. The hull is to thick for the threaded neck so I
would have to fabricate something but the housing, gasket and ball will
work.

--
Glenn Ashmore

I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com

"Jim Conlin" wrote in message
...
Then look at http://www.dinghyshop.com/sunfish/bailer.html


"Glenn Ashmore" wrote in message
news:PKQ9f.39$ii.16@dukeread04...
"Jim Conlin" wrote in

Sunfish had simple bronze suction bailers.. I think they had some kind
of
check ball.

That is sort of what I am looking for. A low profile self bailer with a
check ball.

--
Glenn Ashmore

I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com

Might it make sense to grind thin a section of the cedar 'core' re-glass the
inside and think of it as a sump for the bailer?
Just a guess.
J


"Glenn Ashmore" wrote in message
news:IQS9f.43$ii.3@dukeread04...
.... The hull is to thick for the threaded neck