Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
On Tue, 08 Jul 2003 07:43:33 -0400, Glenn Ashmore
wrote: snip Bonus definition: "Dead rise" is the angle sloping outwards and up from the keel to the topsides below the waterline. And remember that the deck is the part on top of the boat on which you stand or sit, and the topsides are actually the sides of the boat between the waterline stripe and the gunwales. Gunwales are the top edge of the sides. "Tumble home" is the slope leading inward and up from the waterline to the deck. You can see this in cars, which, when viewed from ahead or astern, have tumblehome either from the bottom of the side windows to the roof, or from a design line lower than the windows to the top. Except Volkswagen Eurovans. - Rick Tyler |
#2
![]() |
|||
|
|||
![]()
On Tue, 15 Jul 2003 02:13:34 GMT, Rick Tyler wrote:
On Tue, 08 Jul 2003 07:43:33 -0400, Glenn Ashmore wrote: snip Bonus definition: "Dead rise" is the angle sloping outwards and up from the keel to the topsides below the waterline. And remember that the deck is the part on top of the boat on which you stand or sit, and the topsides are actually the sides of the boat between the waterline stripe and the gunwales. Gunwales are the top edge of the sides. Hmm. Do yachting definitions differ from military nautical definitions? When I was required to "go topside" I went up on deck. When I worked chipping & painting above the waterline & below the gunwales I worked "over the side". Kiyu |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
HELP! Water in bilge when running... | General | |||
Water in the Bilge | General | |||
What's a Bilge Sponge | General | |||
Bob Hope dead at 100 | General |