LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #7   Report Post  
Joe
 
Posts: n/a
Default Outboard Overboard!!!!

"Jonathan Ganz" wrote in message ...
Sometimes, if the engine isn't running, it's not too bad. If it's running
when it goes in, it's generally toast.


Not true. I use to rent outboard skiffs and take them to point loma
near San Deigo. We would check out the kelp fields the seals ect then
surf the boats on the ocean swells breaking on the point. It was a
blast, but often you were swamped going full speed and the engine and
all goes under. We would just drag them up on the beach, dry them out
crank the water thru dry the plugs and sand them with a piece of emery
cloth and go right back to do it again. I found a punt off the ship
channel last year and surfed the ship wakes between morgans point and
the Fred Heartman bridge. Was a blast 3 or 4 miles of surfing on a 13
kt wave until I nose dived into the bottom of the roller and the boat
went head over heels.

Still have the same outboard after having to swim with it and the
upside down boat for a half mile. Secret is just open it up wash, oil
everything and get the water out of were it does not belong.

Got a free outboard once, guy droped it in 14 foot of water. He had to
much money and just said he was going to get a new one. So I dove in
and retrieved it right then. Gave it to a Brit that was crusing thru.

Joe


--
"j" ganz @@
www.sailnow.com

"Bobsprit" wrote in message
...
My buddy managed to drop his 7HP outboard into the water yesterday and rip

out
his thumbnail in the process. More painful than his thumb, the outboard

was in
10 feet of water. We talked about what to do, knowing full well what had

to be
done. I used Alien's whisker pole to locate the engine in the mud. Holding

the
pole to mark the spot, I was able to swim down (after a few tries) and tie

a
line to the motor. We hauled it up.
I carried the motor over to my friend who does the yards outboard work and

an
hour later (fresh water wash, flush, WD 40 flush for head and carb and so

on,
the motor was running as if nothing had happened!
Interesting that when the outboard dropped into the water, my buddy says

it was
floating for a moment! I guess there was enough air in the hat.


RB

 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
dead outboard? Evan Gatehouse Cruising 11 June 16th 04 07:34 PM
Outboard Performance Accessories JGK General 7 April 3rd 04 04:27 AM
Tiller and outboard - which one controls ? Sven General 6 December 6th 03 02:15 AM
Recommend HP + mounting outboard - 27' Sailboat? Dave W Boat Building 3 October 1st 03 01:54 AM
Converting I/O to Outboard with Jack Plate Mile Sullivan General 5 September 19th 03 02:59 AM


All times are GMT +1. The time now is 07:25 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 BoatBanter.com.
The comments are property of their posters.
 

About Us

"It's about Boats"

 

Copyright © 2017