Home |
Search |
Today's Posts |
|
#1
posted to rec.boats
|
|||
|
|||
Had a chance to trade up.
"Short Wave Sportfishing" wrote in message ... On Sat, 2 Aug 2008 13:50:50 -0300, "Don White" wrote: BTW Should I be worried about denting the bottom or pounding rivets out by banging over medium size waves at a good clip? Nah - you aren't going to hit that hard. The boat is built very similar to the way Lund does it - rivets, epoxy sealer at the seams. You'd have to hit pretty hard to loosen one of those rivets. Whoo hooo! Can't wait to get out again. I may have to install a seatbelt on that cushy seat though. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Probably no chance it could happen ere... | General | |||
If you get the chance... | General | |||
'This is your chance to... | General | |||
'This is your chance to... | Boat Building | |||
Little Mikey B>>>>>one last chance | Power Boat Racing |