HK wrote:
John H. wrote:
On Tue, 25 Sep 2007 22:07:42 -0400, Wayne.B
wrote:

On Tue, 25 Sep 2007 15:52:15 -0400, "Reginald P. Smithers III"
wrote:

Needless to say, this will prompt a long discussion on the correct
way to splice or how stupid it is to splice an ant. wire
You never splice coax without using proper connectors and a barrel
splice, all of which introduce some additional losses.
The *right* way is to cut off the original connector, shorten the
cable as needed, and install a new connector.

Is there a 'proper' manner of installing a new connector? Is there a
'proper' type of new connector to install?


Most antenna kits come with an instruction sheet. The instructions
describe in words and drawings how to attach the connector. Only minor
soldering skills are required.

Well I knew this would make for an interesting discussion. I went
online to see what Shakespeare is doing today. 10 yrs ago, they said
"DO NOT CUT CABLE". Today, they provide instructions and a connection,
but say

This antenna will read “open circuit”
when tested with an ohm meter or
continuity tester.
The 50-ohm coaxial cable should
remain at least 3 feet in length,
measured from the point where the
cable exits the antenna.
For installations where the cable
exits through the bottom center of
the antenna’s ferrule, replace the
grommet at the exit hole in the ferrule
with the supplied Grommet Plug.
Connect the antenna to your transceiver with RG-8/X lowloss
coax cable (supplied) and install the PL-259 connector
(supplied). Instructions for connector installation are included
with the connector.


I found a site that showed in more detail than anyone would want, how to
install a PL-259 Connector.

http://www.seed-solutions.com/gregor...SolderCoax.htm

JohnH, enjoy, you have Shakespeare blessing. BUT WHATEVER YOU DO, DON'T
BUY A METZ.