Home |
Search |
Today's Posts |
#3
![]()
posted to rec.boats
|
|||
|
|||
![]()
Have you EVER changed the thermostats??? If not it might be waayy
overdue. The engine does should be around the 130 degree range. Maybe a bit higher or lower depending on the make and existing water temp. Another thing to look at is the waterpump impeller. That should be changed every two seasons or so depending on how much you use your boat. Tom On Mar 19, 1:13 pm, "s o" wrote: hi all, I purchased my first boat with a '84 90 hp evinrude(V4) sometime ago. I found it seems to run hot. When I run it in neutral with the earmuff for a few minutes, I couldn't place my finger on the cylinder flat area for any longer than 1 or 2 sec. there's constant stream from the pee hole but there's also cool water coming out of the small housing betwn the lower unit and the leg, there's no water coming out of the exhaust holes(should there be?) Does this mean the thermostat is stuck closed? I'll take cylinder temp. once I buy the infare gun (saw the ad. for a pocket size one for $10 at harbor freights, are these any good? ) Did a compression test, the readings were 125, 120 on bank 1 and 110, 110 on bank 2. any thoughts on this? thanks s o |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Volvo 4.3 Suddenly Quits | General | |||
Problem with 3 hp Sears Gamefisher / Tanaka 300 | Boat Building | |||
Math Problem | ASA | |||
Confused by OMC 4.3L thermostat housing | General | |||
Johnson outboard problem | General |