Menu

OMC Trim switch help needed

Search this Thread

Prev

Previous Post

Next Post

Next

#3

Report Post

Camilo

Posts: n/a

Default

wrote:
There is not simple easy fix. You can check any plugs that go
from that to the wiring hardness that goes back to the engine.
You're just going to need to trace it down which will take some time.
If its not going in either direction but works from the back
you have a bad connection (most likely power)

You can always see if the switch is just bad by jumpering the
connections
but if you unsure about your electrical skills, leave it up to a good
mechanic.

Tom

Thanks for the reply Tom. After I read your post, I had a DUH moment
almost immediately when I started - I looked back where the cowling
switch wiring was/is and saw where the remote switch met up with that
wiring (three wires - I think - red, blue and green). DUH, the red
wire plug was obviously defective and had come loose! A very easy fix.
Thanks for the reply.

Camilo

Reply With Quote

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is Off HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Float switch alert retraction.	Roger Long	Cruising	0	June 28th 05 09:21 PM
Bilge pump switch	Kalico	Cruising	13	May 25th 05 04:30 PM
MerCrusier 3.0 Power Trim Switch Question?	Larry D Gibbs	General	2	March 21st 05 09:21 PM
Need a suggestion for the trim wiring on my boat	Fish4Fun	General	23	May 5th 04 05:59 AM
Tilt / Trim switch	Ronald A. Widman	General	0	July 20th 03 04:51 PM

All times are GMT +1. The time now is 09:44 PM.

About Us

"It's about Boats"

Contact Us BoatBanter Home Privacy Statement

Copyright © 2017