Fuel consumption for Pro-line 211?
 

Does anyone have something that will tell me what the fuel consumption
expectations are for a Pro-line 211 walkaround with a 5.7L carbureted engine?

It's listed in the Powerboat Guide, which I'm too cheap to buy just to get this
question answered.

I'm also too cheap to put a fuel meter on it.

Actually, I'm so cheap I may not burn the electricity to turn this computer on
to get an answer....but I'll love you if you try.

Thanks!
--
John H

"All decisions are the result of binary thinking."

Roughly 1-22 gph. There are too many variables: Alpha 1, Bravo 1,2, or
3, Volvo Penta, prop selection, load, fuel & water on board, sea
conditions, etc. The most important variable is your speed. You can
burn 1-2 gph at a crawl and about 20-22 at WOT.

If you want to economize - and your post hints to that - you *should*
buy a fuel meter. A boat running 2500 rpms at 21 knots can burn 6 gph
with that engine. That same boat at 3500 rpms and 34 knots can burn
around 12 gph - about double or half of the fuel economy. A fuel flow
meter can help you find your sweet spot, or cruising speed, to get the
best bang for your buck and pay off that meter in a short period of
time. Here's a boat with a Volvo 5.7 that was tested...

RPM MPH Knots GPH
650 3.7 3.2 0.9
1000 5.8 5.0 1.2
1500 8.1 7.0 3.4
2000 15.6 13.6 5.1
2500 24.4 21.2 6.0
3000 31.7 27.6 8.2
3500 39.6 34.4 11.8
4000 45.3 39.4 13.5
4500 49.9 43.3 17.2
4750 54.1 47.0 22.6

Dan




John H wrote:

Does anyone have something that will tell me what the fuel consumption
expectations are for a Pro-line 211 walkaround with a 5.7L carbureted engine?

It's listed in the Powerboat Guide, which I'm too cheap to buy just to get this
question answered.

I'm also too cheap to put a fuel meter on it.

Actually, I'm so cheap I may not burn the electricity to turn this computer on
to get an answer....but I'll love you if you try.

Thanks!

On Sat, 09 Apr 2005 21:34:42 GMT, Dan Krueger
wrote:

Roughly 1-22 gph. There are too many variables: Alpha 1, Bravo 1,2, or
3, Volvo Penta, prop selection, load, fuel & water on board, sea
conditions, etc. The most important variable is your speed. You can
burn 1-2 gph at a crawl and about 20-22 at WOT.

If you want to economize - and your post hints to that - you *should*
buy a fuel meter. A boat running 2500 rpms at 21 knots can burn 6 gph
with that engine. That same boat at 3500 rpms and 34 knots can burn
around 12 gph - about double or half of the fuel economy. A fuel flow
meter can help you find your sweet spot, or cruising speed, to get the
best bang for your buck and pay off that meter in a short period of
time. Here's a boat with a Volvo 5.7 that was tested...

RPM MPH Knots GPH
650 3.7 3.2 0.9
1000 5.8 5.0 1.2
1500 8.1 7.0 3.4
2000 15.6 13.6 5.1
2500 24.4 21.2 6.0
3000 31.7 27.6 8.2
3500 39.6 34.4 11.8
4000 45.3 39.4 13.5
4500 49.9 43.3 17.2
4750 54.1 47.0 22.6

Dan


Thanks Dan, I should have mentioned it has an Alpha I outdrive. It looks like
trolling (8-900 rpm) will burn about 1 gph and cruising (usually about 3200 rpm)
will burn about 10gph. Guess I better spend more time fishing and less time
playing!
--
John H

"All decisions are the result of binary thinking."

On average you will get between 2.5 and 3.0 miles per gallon. This assumes
you are running on plane and are running between 3000 and 4000 rpms. The
lower the rpms the better the mileage.

Everyone wants to quote gallons per hour at a certain rpm. How many hours
do you run at the same rpm? Miles per gallon means so much more as you
should know how far you have gone using either a chart or a gps. This will
tell you exactly how far you can still go on a given amount of fuel.

Of course that is my opinion.
--
Tony
my boats and cars at http://t.thomas.home.mchsi.com


"John H" wrote in message
...
Does anyone have something that will tell me what the fuel consumption
expectations are for a Pro-line 211 walkaround with a 5.7L carbureted
engine?

It's listed in the Powerboat Guide, which I'm too cheap to buy just to get
this
question answered.

I'm also too cheap to put a fuel meter on it.

Actually, I'm so cheap I may not burn the electricity to turn this
computer on
to get an answer....but I'll love you if you try.

Thanks!
--
John H

"All decisions are the result of binary thinking."

On Sat, 09 Apr 2005 22:37:36 GMT, "tony thomas" wrote:

On average you will get between 2.5 and 3.0 miles per gallon. This assumes
you are running on plane and are running between 3000 and 4000 rpms. The
lower the rpms the better the mileage.

Everyone wants to quote gallons per hour at a certain rpm. How many hours
do you run at the same rpm? Miles per gallon means so much more as you
should know how far you have gone using either a chart or a gps. This will
tell you exactly how far you can still go on a given amount of fuel.

Of course that is my opinion.

Actually, Tony, gph is better in my case. When fishing, I am either trolling or
going somewhere on plane and anchoring for a long time (or just drifting). If
trolling, I might be on plane for a half hour and then troll at 1-3 mph for four
or five hours (unless I'm lucky and limit out early!). If bottom fishing, I may
be on plane for an hour getting to the site, and then anchoring for four or five
hours. So I really need to know my planing consumption and my trolling
consumption. That way, if I'm splitting the gas costs with a couple other folks
it'll be fair all around.
--
John H

"All decisions are the result of binary thinking."

Agreed for that situation. But would it not be more fair to start out full
of fuel and then top off when you get back. That way you know exactly how
much you burned.

--
Tony
my boats and cars at http://t.thomas.home.mchsi.com
"John H" wrote in message
...
On Sat, 09 Apr 2005 22:37:36 GMT, "tony thomas"
wrote:

On average you will get between 2.5 and 3.0 miles per gallon. This
assumes
you are running on plane and are running between 3000 and 4000 rpms. The
lower the rpms the better the mileage.

Everyone wants to quote gallons per hour at a certain rpm. How many hours
do you run at the same rpm? Miles per gallon means so much more as you
should know how far you have gone using either a chart or a gps. This
will
tell you exactly how far you can still go on a given amount of fuel.

Of course that is my opinion.

Actually, Tony, gph is better in my case. When fishing, I am either
trolling or
going somewhere on plane and anchoring for a long time (or just drifting).
If
trolling, I might be on plane for a half hour and then troll at 1-3 mph
for four
or five hours (unless I'm lucky and limit out early!). If bottom fishing,
I may
be on plane for an hour getting to the site, and then anchoring for four
or five
hours. So I really need to know my planing consumption and my trolling
consumption. That way, if I'm splitting the gas costs with a couple other
folks
it'll be fair all around.
--
John H

"All decisions are the result of binary thinking."

On Sun, 10 Apr 2005 02:29:07 GMT, "tony thomas" wrote:

Agreed for that situation. But would it not be more fair to start out full
of fuel and then top off when you get back. That way you know exactly how
much you burned.

That would be more accurate, if I wanted to take the time to do so every time I
go out. But, I don't.
--
John H

"All decisions are the result of binary thinking."

Harry is correct.... Also.. If you use your boat a lot then it will
probably pay for itself in a year or two.... I had a pair of 454's in a
Phoenix 33 and it was an eye opener.... found out for that boat, I had
to push it a bit past optimum cruise RPM (Per crusader) to get the best
fuel economy. It also helped me justify the new Cummins 370s I put in
the boat two years later....

Harry Krause wrote:
John H wrote:

On Sun, 10 Apr 2005 02:29:07 GMT, "tony thomas"
wrote:


Agreed for that situation. But would it not be more fair to start
out full of fuel and then top off when you get back. That way you
know exactly how much you burned.



That would be more accurate, if I wanted to take the time to do so
every time I
go out. But, I don't.


For under $150, you can install a fuel-flow meter and be done with it.
You can probably install it yourself.

On Sat, 09 Apr 2005 16:58:45 -0400, John H
wrote:

Does anyone have something that will tell me what the fuel consumption
expectations are for a Pro-line 211 walkaround with a 5.7L carbureted engine?

I owned 2 Pro-Line's. Sold the off for a hefty profit.
--
Bush and the NeoConvicts who control him
are destroying the once-great United States.

"Harry Krause" wrote in message
...
On Sat, 09 Apr 2005 16:58:45 -0400, John H
wrote:

Does anyone have something that will tell me what the fuel consumption
expectations are for a Pro-line 211 walkaround with a 5.7L carbureted
engine?

I owned 2 Pro-Line's. Sold the off for a hefty profit.


Who is this idiot who "clones" the names of posters here and pretends to be
them? He/she isdoing everyone a great disservice.