"Doug Dotson" dougdotson@NOSPAMcablespeedNOSPAMcom wrote in message
...

"JimH" wrote in message
...

"Jay" wrote in message
...
So I finally found a set of speakers that seemed like a good enough deal
and they came in last week. I'm wondering if anyone has any
input/experience installing speakers. They aren't flush mount which
needs I'll need to be cutting a few holes... some of my curiosity lies
in wondering if there's any certain saw blades one should use for
cutting fiberglass.... I was going to just drill a few holes to start a
hand jig saw... maybe tape up the area with duck tape to avoid
scratching.. other than that I didn't really know if there was anything
one should take precaution with.

Also, though they weigh a couple pounds each, should I worry much about
providing some of support to the backing... like a brace to dissipate
weight on the fiberglass walls?

TIA

-j


Always cover the face of the cut/drill area with duct tape...it reduces
the likelihood of the gelcoat chipping.

NEVER use duct tape for masking.

You are correct. I should have said masking tape.