Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Adjusting Minn Kota Endura 30 to 15" spec
Hi,
I have a Sevylor HF280 inflatable. The directions suggest only using a motor with a 15" shaft. The MK is 30". Where do I measure to adjust the MK shaft down so that it would sit in the water at the same depth as a typical 15" length motor, or in other words the Sevylor motor that they sell. The obvious answer might be at 15" I assume but I'm not sure if it might actually be a bit lower since I would think even with a 15" motor the attachment to the transom might be lower than the very top of the whole unit. Thanks, Jesse |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
FS: Minn Kota Power Control in NY | Marketplace | |||
Need Minn Kota 3HP housing | General |