Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
I want to remove the bottom paint from my 268 Sea Ray and wondered if
anyone had any good suggestions or advice. It's been painted several times by the previous owner because it was kept in the water, but I'm using a trailer and hate the look plus the extra drag. I'm sure that whatever has to be done will be time consuming, but my biggest concern is what it will do the gelcoat. Thanks! |
#2
![]() |
|||
|
|||
![]()
Frank
I remove the antifouling build-up frm my yacht every five or six years, and this is what I do. First wear protective clothing including a good carbon-filter mask or positive pressure mask, as antifouling paint is quite toxic. Next use a tungsten blade hand scraper. I find I have more control if I put a very long handle on it - litterally broom-stick length. This will remove the paint build up surprisingly fast but at the expense of a lot of muscle power. Finally finish off with an electric sander. (An electric sander is far slower than a hand scraper in removing any deep build-up). Then apply new paint system. All waste must be collected and disposed of properly and legally as its still toxic, and depending where you are there may be federal, state and local laws. While doing all this remember that antifouling paint is a POISON deliberately applied to the bottom of a boat. If it was not a poison it would not work. Fair scraping Graeme sv Leonidas |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Bottom paint vs performance | General | |||
Interlux Bottom Paint Question | Cruising | |||
Bottom Paint | ASA | |||
white film on green bottom paint, running | General | |||
Removing bottom paint... | General |