Home |
Search |
Today's Posts |
#11
![]() |
|||
|
|||
![]() ".JIMinMA." wrote in message ... "Calif Bill" wrote in message link.net... If starting, the voltage will be below 13.4V and the batteries will not be combined. I installed one on my boat as the electronics power cycled when starting the motor (351W inboard). They happily stay on now. The only isolators I have seen have been the diode units. The combiner is a relay. Bill Your right. I didn't think of that. Battery voltage typically goes to about 10 V when the engine is cranking so the West Combiner/Isolator would be in Isolation mode. How do you handle an emergency start situation when the starting battery is dead? Jim I have a Guest dual battery switch. The combiner is hooked up to the 1 and 2 battery connections and then off the #2 connection is a wire to a single battery switch. The electronics runs off the single switch. So to run the boat I have to turn the dual switch to #1 and also turn on the single switch. If #1 is dead, just turn the dual switch to #2. I lost a Pinpoint sonar unit when starting one time. The EMF kickback from the starter / solenoid blew a cap and the power supply in the unit. Bill |