About Us

John H.[_5_]

On Wed, 26 Aug 2015 12:32:50 -0400, wrote:

On Wed, 26 Aug 2015 12:18:10 -0400, Keyser Söze
wrote:

On 8/26/15 12:03 PM, wrote:
On Wed, 26 Aug 2015 11:09:33 -0400, Keyser Söze
wrote:

On 8/26/15 11:07 AM, wrote:
On Wed, 26 Aug 2015 05:22:58 -0700 (PDT), Tim
wrote:

I have shot one several times. Its angry. Especially at $3. A pull

That is why I say a guy with one, should be reloading. With revolvers,
recovering the brass is not even hard.

It's a buck and a half a shot with factory loads. What's you guess about
reloading, assuming you recycled the brass a few times and were buying
readymade bullets?

You will run into the same issue with bullets as Tim was referencing,
small production runs but a buck a pop would not surprise me for a
performance bullet. Cast bullets should be a lot cheaper., maybe 30-40
cents, way less if you cast your own.. Primers and powder are pennies
a shot.
These hand cannons remind me of the chopper (motorcycles) that were
popular in the 70s. When I questioned the tiny gas tank, the guy said
"if you go that far you will want to get off anyway".
I doubt anyone is going to shoot a lot of full power loads.

I looked a little and there are some "cowboy" loads that push out
subsonic cast bullets and should shoot fairly easy.

The full power load is at least 3-4 times the energy.

I pay about 30 cents a round for decent factory 158 grain .357 MAG
rounds, similar to what I pay for .223 rifle ammo. That seems enough to
spend on ammo to me.

The .500 S&W is not your regular plinker.
It is like comparing a Bugatti to a Camry

Sounds like it would be a great gun for someone who is constantly seeking attention.
Gosh, it would be very photogenic, especially if the photo included lots of ammo.
--

Ban idiots, not guns!

Keyser SÃ¶ze

On 8/26/15 1:44 PM, John H. wrote:
On Wed, 26 Aug 2015 12:32:50 -0400, wrote:

On Wed, 26 Aug 2015 12:18:10 -0400, Keyser Söze
wrote:

On 8/26/15 12:03 PM, wrote:
On Wed, 26 Aug 2015 11:09:33 -0400, Keyser Söze
wrote:

On 8/26/15 11:07 AM, wrote:
On Wed, 26 Aug 2015 05:22:58 -0700 (PDT), Tim
wrote:

I have shot one several times. Its angry. Especially at $3. A pull

That is why I say a guy with one, should be reloading. With revolvers,
recovering the brass is not even hard.

It's a buck and a half a shot with factory loads. What's you guess about
reloading, assuming you recycled the brass a few times and were buying
readymade bullets?

You will run into the same issue with bullets as Tim was referencing,
small production runs but a buck a pop would not surprise me for a
performance bullet. Cast bullets should be a lot cheaper., maybe 30-40
cents, way less if you cast your own.. Primers and powder are pennies
a shot.
These hand cannons remind me of the chopper (motorcycles) that were
popular in the 70s. When I questioned the tiny gas tank, the guy said
"if you go that far you will want to get off anyway".
I doubt anyone is going to shoot a lot of full power loads.

I looked a little and there are some "cowboy" loads that push out
subsonic cast bullets and should shoot fairly easy.

The full power load is at least 3-4 times the energy.

I pay about 30 cents a round for decent factory 158 grain .357 MAG
rounds, similar to what I pay for .223 rifle ammo. That seems enough to
spend on ammo to me.

The .500 S&W is not your regular plinker.
It is like comparing a Bugatti to a Camry

Sounds like it would be a great gun for someone who is constantly seeking attention.
Gosh, it would be very photogenic, especially if the photo included lots of ammo.

You should get one and tape it onto the side of the guitar case you take
to your Old White Boys Hootenannies.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Holland - "Good Speed-Sas Van Gent-Netherlands 1.JPG" (2/2) 641.5 KBytes yEnc	[email protected]	Tall Ship Photos	0	October 11th 07 11:27 PM
Holland - "Good Speed-Sas Van Gent-Netherlands 1.JPG" (1/2) 641.5 KBytes yEnc	[email protected]	Tall Ship Photos	0	October 11th 07 11:27 PM
I "knew" there was a connection between JimH and Skipper...	[email protected]	General	17	December 9th 05 12:53 AM
I "knew" there was a connection between JimH and Skipper...	JimH	General	3	December 6th 05 01:47 PM
I "knew" there was a connection between JimH and Skipper...	John H.	General	0	December 5th 05 09:43 PM

Menu

About Us