About Us

Keyser SÃ¶ze

On 8/26/15 12:03 PM, wrote:
On Wed, 26 Aug 2015 11:09:33 -0400, Keyser SÃ¶ze
wrote:

On 8/26/15 11:07 AM, wrote:
On Wed, 26 Aug 2015 05:22:58 -0700 (PDT), Tim
wrote:

I have shot one several times. Its angry. Especially at $3. A pull

That is why I say a guy with one, should be reloading. With revolvers,
recovering the brass is not even hard.

It's a buck and a half a shot with factory loads. What's you guess about
reloading, assuming you recycled the brass a few times and were buying
readymade bullets?

You will run into the same issue with bullets as Tim was referencing,
small production runs but a buck a pop would not surprise me for a
performance bullet. Cast bullets should be a lot cheaper., maybe 30-40
cents, way less if you cast your own.. Primers and powder are pennies
a shot.
These hand cannons remind me of the chopper (motorcycles) that were
popular in the 70s. When I questioned the tiny gas tank, the guy said
"if you go that far you will want to get off anyway".
I doubt anyone is going to shoot a lot of full power loads.

I looked a little and there are some "cowboy" loads that push out
subsonic cast bullets and should shoot fairly easy.

The full power load is at least 3-4 times the energy.

I pay about 30 cents a round for decent factory 158 grain .357 MAG
rounds, similar to what I pay for .223 rifle ammo. That seems enough to
spend on ammo to me.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Holland - "Good Speed-Sas Van Gent-Netherlands 1.JPG" (2/2) 641.5 KBytes yEnc	[email protected]	Tall Ship Photos	0	October 11th 07 11:27 PM
Holland - "Good Speed-Sas Van Gent-Netherlands 1.JPG" (1/2) 641.5 KBytes yEnc	[email protected]	Tall Ship Photos	0	October 11th 07 11:27 PM
I "knew" there was a connection between JimH and Skipper...	[email protected]	General	17	December 9th 05 12:53 AM
I "knew" there was a connection between JimH and Skipper...	JimH	General	3	December 6th 05 01:47 PM
I "knew" there was a connection between JimH and Skipper...	John H.	General	0	December 5th 05 09:43 PM

Menu

About Us