Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Quicksilver LaserII
I picked up a used SS prop for my 2003 Mercury 125hp Sal****er motor. It's
a Quicksilver Laser II. Part number is 48-16992A40 22P. What do I need in the way of a thrust washer? I believe I need a 13191A1 washer. Is that correct? And where can I purchase one on LI (Nassau)? Also, any opinions on the prop? The original is a 12.75x21 RH and this is a 13.75x22 RH. Anyone forsee any problems? WOT presently is 5000rpm. Mercury says WOT should be between 4750 and 5200. Thanks. |
#2
|
|||
|
|||
Quicksilver LaserII
I forsee no operational problems....... but you'll have to sort it out with
the dealer if you need a different thrust washer. -W "Mole" wrote in message t... I picked up a used SS prop for my 2003 Mercury 125hp Sal****er motor. It's a Quicksilver Laser II. Part number is 48-16992A40 22P. What do I need in the way of a thrust washer? I believe I need a 13191A1 washer. Is that correct? And where can I purchase one on LI (Nassau)? Also, any opinions on the prop? The original is a 12.75x21 RH and this is a 13.75x22 RH. Anyone forsee any problems? WOT presently is 5000rpm. Mercury says WOT should be between 4750 and 5200. Thanks. |
#3
|
|||
|
|||
Quicksilver LaserII
I've been told the same thing about different props. To date, I have NOT
had to purchase a different thrust washer to make either a Stiletto, Ron Hill, Quicksilver SS or original Alum prop work on either of my alpha one drives. YEs, I'm kind of crazy and have purchased and sold a dozen props on e-bay to find the ones that were 'right' for various applications (i.e. one for just cruising, one for pulling tubes and skiers, etc). One was a 1990 MR drive hooked to a 3.0L and now I have a 2003 Gen 2drive hooked to a 5.0L and so far everything has fit with the same OEM washer. WRT the prop "working", that is a decision you have to make if it suits your needs. You need to find a combination of pitch and blade size (and quantity) that works for what you want. For instance, my new 5.0L came with a 21P Alum prop. I tried several and have found for 'general use' the best is a 4 blade 20P Stilletto. However, I'm still keeping my 19P 3 blade Stilletto (give a little better hole shot) and my 21P Quicksilver (better for light loads and when top speed is important) and sold my 17P props leftover from the 3.0L days on e-bay. Your application may be different, but I'd try it first before spending the $$. Hope this helps Steve L. "Mole" wrote in message t... I picked up a used SS prop for my 2003 Mercury 125hp Sal****er motor. It's a Quicksilver Laser II. Part number is 48-16992A40 22P. What do I need in the way of a thrust washer? I believe I need a 13191A1 washer. Is that correct? And where can I purchase one on LI (Nassau)? Also, any opinions on the prop? The original is a 12.75x21 RH and this is a 13.75x22 RH. Anyone forsee any problems? WOT presently is 5000rpm. Mercury says WOT should be between 4750 and 5200. Thanks. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|