Quicksilver LaserII
 

I picked up a used SS prop for my 2003 Mercury 125hp Sal****er motor. It's
a Quicksilver Laser II. Part number is 48-16992A40 22P. What do I need in
the way of a thrust washer? I believe I need a 13191A1 washer. Is that
correct? And where can I purchase one on LI (Nassau)?

Also, any opinions on the prop? The original is a 12.75x21 RH and this is a
13.75x22 RH. Anyone forsee any problems? WOT presently is 5000rpm.
Mercury says WOT should be between 4750 and 5200. Thanks.

Quicksilver LaserII
 

I forsee no operational problems....... but you'll have to sort it out with
the dealer if you need a different thrust washer.

-W

"Mole" wrote in message
t...
I picked up a used SS prop for my 2003 Mercury 125hp Sal****er motor.
It's
a Quicksilver Laser II. Part number is 48-16992A40 22P. What do I need
in
the way of a thrust washer? I believe I need a 13191A1 washer. Is that
correct? And where can I purchase one on LI (Nassau)?

Also, any opinions on the prop? The original is a 12.75x21 RH and this is
a
13.75x22 RH. Anyone forsee any problems? WOT presently is 5000rpm.
Mercury says WOT should be between 4750 and 5200. Thanks.

Quicksilver LaserII
 

I've been told the same thing about different props. To date, I have NOT
had to purchase a different thrust washer to make either a Stiletto, Ron
Hill, Quicksilver SS or original Alum prop work on either of my alpha one
drives. YEs, I'm kind of crazy and have purchased and sold a dozen props on
e-bay to find the ones that were 'right' for various applications (i.e. one
for just cruising, one for pulling tubes and skiers, etc).

One was a 1990 MR drive hooked to a 3.0L and now I have a 2003 Gen 2drive
hooked to a 5.0L and so far everything has fit with the same OEM washer.

WRT the prop "working", that is a decision you have to make if it suits your
needs. You need to find a combination of pitch and blade size (and
quantity) that works for what you want. For instance, my new 5.0L came with
a 21P Alum prop. I tried several and have found for 'general use' the best
is a 4 blade 20P Stilletto. However, I'm still keeping my 19P 3 blade
Stilletto (give a little better hole shot) and my 21P Quicksilver (better
for light loads and when top speed is important) and sold my 17P props
leftover from the 3.0L days on e-bay.

Your application may be different, but I'd try it first before spending the
$$. Hope this helps

Steve L.


"Mole" wrote in message
t...
I picked up a used SS prop for my 2003 Mercury 125hp Sal****er motor.
It's
a Quicksilver Laser II. Part number is 48-16992A40 22P. What do I need
in
the way of a thrust washer? I believe I need a 13191A1 washer. Is that
correct? And where can I purchase one on LI (Nassau)?

Also, any opinions on the prop? The original is a 12.75x21 RH and this is
a
13.75x22 RH. Anyone forsee any problems? WOT presently is 5000rpm.
Mercury says WOT should be between 4750 and 5200. Thanks.